Maher Terminals Inc.

A crane mechanic was unlocking a stuck twist lock on a crane spreader when the tip of his left thumb was pinched in the twist-lock mechanism, resulting in an amputation.

An employee was driving a straddle when the equipment tipped over.

An employee was tossing a damaged toilet into a compactor. The toilet bounced off the compactor and lacerated the employee's right wrist, cutting an artery and tendon.

An employee was operating a hydraulic jack to bend a frame when the jack came loose and struck the employee. They were hospitalized for a spleen injury.

A truck had been towed into the shop with a flat tire and a blown airbag. An employee checked the tire for damage and was airing the tire. The employee was installing the valve core when the bead slipped off the rim. Air escaped, and the aluminum wheel struck the employee's head and face. The employee became unresponsive and was bleeding.

On December 14, 2023, at 8:40 p.m., three employees were inspecting milling machines for startup. A few of the sleeves on the mill drum needed to be changed out. The injured employee was trying to input a sleeve on the mill drum using a hammer. The hammer hit the edge of the drum, which caused a metal piece to splinter off and strike the employee's cheek just below the left eye. The metal splinter embedded in the back of their eye socket, resulting in pain, swelling, and bleeding that required hospitalization.

An employee was pushing a line of carts into a vestibule when the door cable snapped and struck his right ankle. The employee suffered a fracture that required surgery and hospitalization.

An employee was conducting welding repairs inside a ballast water tank on a docked ship. The employee began to experience signs of heat exhaustion, resulting in hospitalization.

An employee was stacking steel pipes and securing loose pieces when a unit rolled from the stack and struck his lower right leg. He sustained a lower right leg fracture.

An employee was removing sheet metal from a flat roof. He unhooked his personal fall arrest system (PFAS) to walk to a different location. He stepped on an unsupported end of the sheet metal and the sheet metal folded, causing the employee to fall approximately 15 feet to the cement floor. The employee sustained fractures to his wrist, hip, and femur.

An employee was opening the door of a container. His finger got caught between the container doors, resulting in a fingertip amputation.

An employee was removing bailing wire from the floor. As they bent down to pick up the wire, a strand of bailing wire that was sticking up from the floor went under his safety glasses and struck his eye.

An employee tripped over a stool and fell on the floor, resulting in a left displaced mid-cervical femoral neck fracture.

An employee was installing fence posts when they stepped into a recently dug hole that was not visible due to rainfall. The employee's leg was fractured.

An employee assisted in cleaning material from a conveyor pit. After the pit was cleaned, the employee proceeded to replace metal safety plates to ensure other employees did not fall into the pit. While replacing one of the last plates, the employee mis-stepped and fell approximately 5 feet into the pit. The employee was hospitalized with back/side bruising, elbow bruising, bone bruises, and/or fractured ribs.

An employee was inspecting a breaker box and turning on/off a circuit breaker when he was electrocuted.

An employee was walking on the sidewalk. When they stepped off the curb, they fell to the ground, resulting in fractures to their tibia, fibula, and a metatarsal.