Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Beaver Holdings, Inc., 314 Industrial Blvd, SHELL LAKE, WISCONSIN 54871
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Watch Beaver Holdings, Inc. — freeGet an email when a new federal OSHA severe-injury report for Beaver Holdings, Inc. is published. One employer, no account, unsubscribe in one click.
Final narrative
At 3:00 p.m. on April 28, 2022, an employee was running a jointer when it amputated his right middle finger.
On June 3, 2024, at approximately 9:29 AM, an employee was using a rotating cutter on a wood shaper machine to cut rabbets in door panels. He was placing tape over some openings between the fence and the top cover to prevent wood dust from blowing out of the machine when his right middle finger contacted the cutter resulting in a fingertip amputation.
On February 8, 2024, at 6:40 a.m., an employee was operating a hinge boring machine when the back of his left gloved hand was caught by a rotating 35-mm bit, resulting in a circular puncture injury that required surgery.
An employee was processing a board through the jointer to square off the board. The employee's hand slipped off of the board and went into the blade of the jointer, amputating the fingertip of the right middle finger.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 321999)
An employee was using a telehandler to move pallets of pellets from a pod. The employee exited the telehandler to pick up a sacrificial pallet that is placed under the bottom layer of pallets. When the employee turned to pull the pallet away, the top two tiers of the pod fell on him. The employee sustained a fractured ankle, three fractured ribs, and fractured vertebrae.
An employee was preparing to replace a belt on a fan drive assembly. He went to manually stop the fan and was caught by the belt. His hand was pulled into the machine and his left little fingertip was amputated.
An employee was cutting remanufactured lumber with a chainsaw when a board fell and struck his left hand, causing his left hand to move off the chainsaw. While he was moving his hand back, the chainsaw kicked back and lacerated the top of his left hand. The employee was hospitalized.
The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.
An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.
A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.
An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.
An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.