Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Amentum Services, Inc., 9892 Slipway Avenue Building # 394 Blount Island, JACKSONVILLE, FLORIDA 32226
on — Amputations, affecting the fingertip(s).
Final narrative
On May 5, 2022, an employee was operating a sheet metal shearing machine when a safety guard came down and amputated the employee's left middle fingertip.
An employee was standing on the ship's gangway setting up equipment in preparation for maintenance to be performed on the gangway. As she was tightening the safety rope that was tied around a bar that holds the gangway in place, the rope broke, causing her to slip and fall backward. She sustained a hematoma and laceration to the back of the head as well as a right elbow fracture.
On January 27, 2025, an employee was stepping down from the wing of a training aircraft when he lost his balance with one foot on the hangar floor and fell onto his left side. The employee was hospitalized with a left femur fracture and required surgery.
An employee was removing an air brake chamber from a vehicle when their right index finger became pinched between the chamber and the frame of the vehicle, resulting in an amputation up to the first knuckle.
An employee was greasing the chain on a conveyor when their gloved right hand was pulled into the chain and sprocket and the index fingertip was amputated.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 488190)
Two employees fell from an access bridge while entering an aircraft to perform maintenance. They landed on the ground about 20 feet below, where one of them lost consciousness. One employee sustained a fractured knee and another employee sustained a back strain/sprain. Both employees were hospitalized.
An employee experienced sharp pain in his lower torso area while loading baggage into the front cargo pit of an aircraft. The employee sustained a hernia.
The injured employee was assisting in the disassembly phase after a radar array had been lowered and secured. The crew began removing load bearing pins from an overhead crane to free the radome. A load bearing pin was stuck. The injured employee went to remove the pin manually as a second team member applied pressure from the opposite side. The pin unexpectedly released and struck the injured employee s right thumb, resulting in partial amputation of the distal phalanx including an open distal phalanx fracture and nail bed laceration.
On September 11, 2025, an employee was lowering a railing system on an aircraft fueling cart when his gloved right ring finger was caught in the folding railing system, resulting in a fingertip amputation that required hospitalization and surgical reattachment.
An employee was working at ground level when an aviation engine cylinder weighing 30 pounds fell from a seven-foot high shelf and struck the employee on the head. The employee suffered a fractured skull and was hospitalized.
An employee was helping a coworker transport a tall palm tree with a mini skid steer. The employee was severely shocked by a high-voltage electrical wire above the ground.
An employee was retrieving a Christmas tree from a shelf using a ladder. He missed a step and fell to the concrete floor. He sustained injury to his head and wrist.
An employee was operating an agricultural tractor during sugarcane harvesting. The employee sustained a lumbar sprain due to vibration or motion from the tractor.
An employee was moving a 3-ton condensing unit, strapped down on a dolly, out of a garage. The strap broke, causing the employee to fall backward onto the brick pavered driveway. The employee suffered injury to a spinal ligament in the neck.