I & S Inc of New York

An employee was using a shepherd's hook to help position a jib crane. The hook slipped and the employee fell into an adjacent structure, suffering three broken ribs and a punctured lung.

An employee was taking measurements of a parapet cap when they fell to the ground sustaining fractures to a shoulder and arm.

An employee was cleaning a two-story house. They fell approximately 12 feet from the roof to the floor and sustained fractures to both wrists.

An employee was using a water hose to clean the outside of a wastewater drain system when he fell into an area of the drain that was not covered. Hot water and chemicals caused first, second, and third-degree burns all over the employee's body. The employee was hospitalized.

An employee was cutting down a steel above-ground storage tank. He was on the roof of the tank when he fell 20 feet to the ground, resulting in a broken elbow and sprained leg. The employee was wearing a harness that was tied off at the time.

An employee was operating an aerial work platform. While the employee was maneuvering the lift through a set of double doors, their head was caught between the door frame and the platform's vertical mast. The employee suffered a skull fracture that required surgery.

An employee was transporting used filter media (containing pyrophoric iron sulfide) from an inlet gas separator in the bed of a truck. The material ignited. While the employee was removing items from the truck bed, a gas can was exposed to the fire and off-gassing vapors ignited. The employee suffered first- and second-degree burns to both arms, the chest, the neck, and the right ear. The employee was hospitalized.

An employee was using a pipe threading machine to thread a 2-inch diameter gas pipe during the rebuilding of a gas meter. The pipe was in a vise mounted on the back of the crew truck. A few pieces of metal chips or shavings caused the threading machine to jam. The employee started to back the pipe up, but it jammed in that direction as well. While reaching to pull the handle back up into place to try and start again, the machine rotated about an inch and pinched his middle fingertip against the edge of the truck s back step. The employee's fingertip was partially amputated without loss of bone.

The injured employee was manually lowering a ramp on a heavy equipment trailer with the assistance of another employee. The injured employee was standing behind the trailer ramp. After removing the safety pins, the ramp descended quickly and struck the injured employee, causing them to fall to the ground. The employee was hospitalized with fractures to their sternum and L1 vertebra.

An employee was lighting a tankless water heater when an explosion occurred and the employee was burned.

An employee was closing a door when the door closed on their right index finger, resulting in a fingertip amputation.

An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.

An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.

An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.

An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.