King Steel Corporation

An employee was moving a steel bundle with an overhead crane when the wrong button was depressed on the overhead crane controls, causing the steel load to crush him. He suffered a fractured hip or pelvis.

An employee was unloading bundles of steel pipes from a truck when a bundle broke loose and rolled onto the employee's foot resulting in a broken toe.

An employee suffered severe cuts to the left arm while cleaning a saw. The saw was not locked out at the time of the incident.

An employee was operating a machine when a wire pulled his right glove resulting in amputation of the index and middle fingertips.

An employee was grinding chicken when their right index fingertip was caught in the grinder and amputated.

An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.

An employee was passing through a large metal door when the door closed on the employee, resulting in a cracked rib.

An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.

On October 7, 2025, an employee was pulling a customer load out of post-wash equipment when his left index finger was pinched between the sled and the roller on the charge cart conveyor, resulting in a fingertip amputation between the nail and first joint.

An employee was welding a bearing on a piece of equipment. He was lying on the belt while performing this task. The welding rod contacted the employee or the belt and the employee was shocked by electricity. The employee was hospitalized.

An employee was lighting a pilot light that burns off residual oxygen in the purge chamber of a heat-treating furnace. Residual gas and built-up oxygen in the purge chamber caused an explosion, which blew the front of the furnace's door off its track and the hood/exhaust system off its rivets. The employee was knocked down and suffered burns and lacerations to the left side of his face.

A temporary employee was moving a load using a walk-behind powered industrial vehicle (PIV). He backed into a safety bollard and his leg was pinned between the PIV and the bollard, resulting in a crush injury and laceration to the lower leg. The employee was hospitalized for surgery.

An employee was setting up a work piece on the honing machine when his left hand fingers were crushed in a pinch point. The employee sustained an amputation of the distal joint of his ring finger.

An employee was stacking concrete blocks for a concrete bunker. As a block was swinging into place, the employee's left leg was pinched between two blocks, resulting in injuries to his left heel and lower leg.

An employee was climbing a ladder to inspect a vent in a restaurant dining area. The ladder slid out on the floor and the employee fell approximately 12 feet onto the ladder and the floor. He was hospitalized with a dislocated shoulder and a back injury.

An employee was rappelling down a tree. When he was most of the way down, he fell on the ground and suffered a broken pelvis.

An employee was filtering a fryer with a fryer filter machine. After going around the corner and then returning to the fryers, the employee stepped into the filter machine. The hot oil burned the employee's right ankle, and the employee was hospitalized.

An employee was cleaning out corn from a grain bin. The sweep auger in the bin was activated and caught his trouser leg. His leg was pulled into the auger, which injured his calf and caused leg fractures and lacerations.