Caught, entangled in running powered equipment normal operation · Amputations involving bone loss
At a glance
Federal OSHA recorded a severe workplace injury
at Thomson Lamination Co. Inc., 504 E. Linwood Avenue, MAPLE SHADE, NEW JERSEY 08052
on — Amputations involving bone loss, affecting the Other finger(s) n.e.c..
Final narrative
An employee was setting up a work piece on the honing machine when his left hand fingers were crushed in a pinch point. The employee sustained an amputation of the distal joint of his ring finger.
Amputation Other finger(s) n.e.c. Honing, polishing, lapping machinery
An employee was operating a metal roller machine to roll a small piece of metal. The employee's right index finger became caught between the metal and the machine, and the fingertip was amputated.
An employee was working on a production line. The employee went to retrieve parts that came out of the parts holder, and their left hand became caught between a chain and a sprocket. Three fingers on the hand were amputated.
An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.
An employee was operating a pad printer. The employee's finger was caught in the printer and they suffered a fingertip amputation. The part of the printer that caught the employee's finger was unguarded at the time.
More severe injuries in this industry (NAICS 332811)
On October 7, 2025, an employee was pulling a customer load out of post-wash equipment when his left index finger was pinched between the sled and the roller on the charge cart conveyor, resulting in a fingertip amputation between the nail and first joint.
An employee was welding a bearing on a piece of equipment. He was lying on the belt while performing this task. The welding rod contacted the employee or the belt and the employee was shocked by electricity. The employee was hospitalized.
An employee was lighting a pilot light that burns off residual oxygen in the purge chamber of a heat-treating furnace. Residual gas and built-up oxygen in the purge chamber caused an explosion, which blew the front of the furnace's door off its track and the hood/exhaust system off its rivets. The employee was knocked down and suffered burns and lacerations to the left side of his face.
A temporary employee was moving a load using a walk-behind powered industrial vehicle (PIV). He backed into a safety bollard and his leg was pinned between the PIV and the bollard, resulting in a crush injury and laceration to the lower leg. The employee was hospitalized for surgery.
An employee was walking up a flight of stairs when they tripped on the top step and fell onto the landing. The employee sustained a broken hip and a shoulder injury.
An employee was installing fence posts when they stepped into a recently dug hole that was not visible due to rainfall. The employee's leg was fractured.
An employee assisted in cleaning material from a conveyor pit. After the pit was cleaned, the employee proceeded to replace metal safety plates to ensure other employees did not fall into the pit. While replacing one of the last plates, the employee mis-stepped and fell approximately 5 feet into the pit. The employee was hospitalized with back/side bruising, elbow bruising, bone bruises, and/or fractured ribs.
An employee was walking on the sidewalk. When they stepped off the curb, they fell to the ground, resulting in fractures to their tibia, fibula, and a metatarsal.