Federal OSHA recorded a severe workplace injury
at Ameron Pole Products LLC, 1860 Electronics Drive, ANNISTON, ALABAMA 36207
on — Cuts, lacerations, affecting the heel(s).
Final narrative
An employee was moving OHC from a molding area to a caging area. The employee stepped onto a motorized cart while the cart was in motion. The employee's left foot was pinched between the cart support and a rail resulting in a laceration to the heel.
An employee was moving a pole from a cart to a work table when their left middle finger became caught between the board and the sawhorse as it was lowered into place. The employee sustained a partial amputation to the finger.
On 02/29/2016 an employee was grinding a steel plate when the work stock got wedged. The work stock flipped up pinching his thumb tip between the work stock and the grinding disc. The employee was taken to the hospital for medical treatment. The employee's right thumb tip was later amputated.
An employee was using a dozer to clear a plot of land. The dozer struck the ground after getting stuck on a tree stump, causing the employee to hit their head on the cab roof. The employee sustained a spinal compression injury.
On August 31, 2023, an employee was operating an excavator to complete a demolition job. As the excavator drove into the first floor of the building, the floor collapsed. The vehicle and employee dropped approximately 8 feet, causing the employee to sustain a back injury.
An employee was standing on a walk-behind lawn mower when the mower spun out of control. His right ring fingertip became caught in the handlebar, resulting in an amputation.
An employee was loading a bundle of 3/8-inch rebar using a standup skid loader. While transporting the load, the equipment tipped forward, throwing the employee over the controls and into the mast of the skid loader. The employee sustained several teeth avulsions, a mouth laceration, and bruising/swelling around the face.
An employee was driving a forklift to deliver lumber to a work site when the forklift tipped forward onto the forks. The employee struck his head on a metal railing on the forklift, resulting in a laceration, a concussion, and temporary loss of consciousness.
More severe injuries in this industry (NAICS 327390)
An employee was stacking concrete blocks for a concrete bunker. As a block was swinging into place, the employee's left leg was pinched between two blocks, resulting in injuries to his left heel and lower leg.
An employee was patching precast concrete. He fell from a concrete wall support to the ground due to wind. He was hospitalized with fractures to his left ankle and right knee.
An employee was cutting wood on a table saw when the wood got jammed. While clearing the jam, the wood moved forward and his left index and middle fingertips were amputated.
An employee was traveling down the maintenance aisle of a warehouse on a single-pallet front rider jack. The jack malfunctioned, causing the brakes to apply; the employee fell forward onto the concrete warehouse floor. The employee suffered an injury to the left leg and was hospitalized, requiring surgery.
An employee was operating a metal roller machine to roll a small piece of metal. The employee's right index finger became caught between the metal and the machine, and the fingertip was amputated.
An employee was directing a truck driver to a dump site when the truck's peanut trailer slipped off the kingpin. As the trailer fell, a ladder attached to it lacerated the employee's ear. The employee was hospitalized.
An employee was unloading a forklift from a trailer to the ground. The employee was climbing down the ladder of the trailer when their foot slipped through one of the rungs, causing them to fall backward onto the forklift forks. The employee was hospitalized for fractured ribs.