Centerline Logistics Corporation

An employee was operating a machine when a wire pulled his right glove resulting in amputation of the index and middle fingertips.

An employee was grinding chicken when their right index fingertip was caught in the grinder and amputated.

An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.

An employee was passing through a large metal door when the door closed on the employee, resulting in a cracked rib.

An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.

A driver was loading a trailer. The driver fell out the back of the trailer and fractured his left elbow on the ground. The employee was hospitalized.

An employee was picking bulk bags for shipments. While cleaning pellets off the ground, a stacked bulk bag (full of plastic pellets) collapsed and fell on the employee. The employee sustained fractures to their ribs, pelvis, and left femur.

An employee was delivering goods to a customer. He was folding the truck's lift gate when his left middle finger was pinched in the lift gate, resulting in an amputation.

An employee was operating an electric pallet jack, delivering pallets of groceries to a store. The employee was walking backward when her foot was pinned between the pallet jack and a video pole, resulting in lacerations and fractures to her ankle and heel. She was hospitalized.

An employee was tightening a turnbuckle while attempting to conduct lash-back operations on a ship when their left gloved hand was caught between the upper and lower turnbuckles. The employee suffered a crush injury to the little finger that resulted in a fingertip amputation.

An employee was drilling a hole into the sealed hold of a vessel so a marine chemist could test its atmosphere. Upon drilling the hole, a gas that was under pressure was released and caught fire at the drill motor, where the employee was holding it. The employee was burned.

An employee was performing restoration activities outside a 45-gallon condensation tank of a boiler system. As they were performing post-maintenance activities after repairing one of the two discharge pumps, one of the discharge valves would not open. The employee closed the intake pump to cool off the system and open the discharge valve. Two employees opened the inlet valve to return the tank to service. After they cracked open the inlet valve, a side wall of the tank blew out, causing the injured employee to suffer steam burns to half their body.

An employee was testing and troubleshooting the gang cylinder valve located in the gang area of the sawmill. The employee's fingertip was amputated by the gang cylinder valve.

An employee was unlocking containers on deck. The employee was de-lashing while standing on the edge of the lid. The lashing bar he was holding came off the cone, causing him to turn 90 degrees and strike a railing behind him. The employee sustained four fractured ribs.

An employee parked a side-by-side on the fixed internal ramp aboard a cargo ship. They exited the side-by-side and went to inspect the cargo below. The side-by-side rolled toward the employee and struck them as they were walking toward the edge of the ramp. The employee was knocked off the ramp and landed on the lower deck approximately 8 feet below. The employee was hospitalized with a fractured shoulder.