Illinois Piping Corporation

An employee was checking an HVAC unit in the attic when they fell approximately 15 feet through the rafters to the floor. The employee sustained fractures to the ribs and scapula as well as a collapsed lung.

An employee was removing grating to change metal chip hoppers located in a pit. The employee lost his balance and fell approximately 12 feet from the grate, landing in the metal chip hopper. The employee sustained a sprained right foot, a left foot fracture, and a fractured L5 vertebra.

An employee was reviewing the next steps to take with the foreman when some material fell from above and landed near them. The injured employee then looked up, took a step on the catwalk, and fell through a gap, landing on the ground 15 feet below. The employee sustained three fractured vertebrae and a head laceration.

0n November 16, 2023, an employee was climbing onto a catwalk to cut valves for unit heaters in a building. The employee fell 14 feet through the attic onto the concrete floor, resulting in a fractured pelvis.

An employee was removing a rooftop curb when they fell approximately 15 feet through an opening in the roof, resulting in a fractured leg that required hospitalization.

An employee was rolling a pipe in a cutting rack and his right little finger became caught between sections of the pipe. The employee's finger was surgically amputated.

An employee was working a vertical bandsaw, cutting half-inch diameter rods into pieces. While using a steel chisel to move the cut pieces, the blade caught his leather glove and pulled his index finger in. The employee sustained an amputation of the finger between the first and second knuckle.

An employee was operating a lathe in a machine shop. The rotating head of the lathe caught the employee's left glove, resulting in a compound open fracture to the left wrist and a laceration to left ear.

An employee was descending the stairs of an oil/gas rig. As he approached the fifth step from the bottom, he slipped. His left ankle was caught in the steps, and he suffered fractures to the left fibula, tibia, and talus. He was hospitalized, requiring surgery.

The injured employee was loading a piece of pipe into a pipe bending machine. He had his right hand on the front of the loader while his left hand supported the piece of pipe in the back. A second operator had slightly clamped around the pipe to keep it in place. The third operator called out a measurement. The machine actuated and caught the the injured employee's left middle and ring fingers between the wiper and the material. The employee required surgery and sustained amputations to the distal joint of the middle and ring fingers.

An employee fell while moving a water canister, resulting in fractures to four fingers on her right hand.

An employee was changing a die in a press when the die slipped and crushed the employee's left index finger. The employee sustained an open facture of the tuft of the left distal phalanx and a partial amputation.

An employee was mixing sauce using a sauce barrel mixer when his left little finger was amputated.

An employee was driving a boom lift (in the lowered position) in an exterior dock area. The lift s left wheels rolled onto base plates that covered a 3-foot-deep sump pit. The base plates failed, and one side of the lift dropped. The employee's left leg was caught under the lift basket, and he suffered a fracture to the lower leg including the ankle.

A temporary employee was carrying a nail gun through the warehouse when it hit his leg, activated, and fired a nail into the leg.