Loureiro Building Construction, LLC

An employee was checking an HVAC unit in the attic when they fell approximately 15 feet through the rafters to the floor. The employee sustained fractures to the ribs and scapula as well as a collapsed lung.

An employee was removing grating to change metal chip hoppers located in a pit. The employee lost his balance and fell approximately 12 feet from the grate, landing in the metal chip hopper. The employee sustained a sprained right foot, a left foot fracture, and a fractured L5 vertebra.

An employee was reviewing the next steps to take with the foreman when some material fell from above and landed near them. The injured employee then looked up, took a step on the catwalk, and fell through a gap, landing on the ground 15 feet below. The employee sustained three fractured vertebrae and a head laceration.

0n November 16, 2023, an employee was climbing onto a catwalk to cut valves for unit heaters in a building. The employee fell 14 feet through the attic onto the concrete floor, resulting in a fractured pelvis.

An employee was removing a rooftop curb when they fell approximately 15 feet through an opening in the roof, resulting in a fractured leg that required hospitalization.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.

Employees were securing the fuel line of an outboard motor in preparation for removing the motor from a small vessel located in the equipment yard. A gasoline-related fire occurred and one employee sustained burns to both hands and forearms.

A marine diver/construction worker was working underwater, using a hydraulic dredge to clear sediment away from the base of a dam. The dredge's suction nozzle began migrating toward him, and then pulled in his right hand and forearm. He sustained compartment syndrome in the hand and forearm.

An employee was standing on a sheet of -inch by 4-foot by 8-foot plywood on top of a rebar mat, supervising his crew. As he was moving to alert the crew to an incoming overhead load, he stepped off the plywood and his left foot slipped through the rebar mat and landed on the rebar mat below. His left ankle was broken and dislocated.

An employee was checking on a machine outside of the building and removed a cover to clean out a blocked area. His hand was caught by a rotary valve in a dust collection machine. The employee's fingertip was amputated.

An employee was working to clean a glue roller with a scraper tool. The tool and the employee's left thumb were pinched between two rollers, resulting in a partial amputation.

An employee was re-arranging boxes of pipe insulation on a pallet. One of the boxes fell from the pallet and knocked over an upright empty cylinder. The cylinder fell and crushed the tip of the employee's right toe. The employee's toe required surgical amputation.

An employee was securing the claw of a grapple truck to the truck bed. His left little finger was caught between the tie down strap and the rub rail of the truck, resulting in partial amputation of the finger.

An employee was cutting extruded aluminum framing material using a horizontal band saw. She went to grab a rag in the machine when the rag contacted the blade and pulled her hand in toward the blade, resulting in a partial amputation of the right index finger.