Struck against moving part of machinery or equipment · Cuts, lacerations
At a glance
Federal OSHA recorded a severe workplace injury
at Dream Construction, Inc., 187 Skyridge Avenue, SPEARFISH, SOUTH DAKOTA 57783
on — Cuts, lacerations, affecting the hand(s), unspecified.
Final narrative
An employee was cutting medium-density fiberboard for a residential project using a table saw when his hand contacted the saw blade and was lacerated.
An employee was operating a strip saw. As the employee shut off the saw, their right index and middle fingertips were amputated by the blade before it came to a complete stop.
An employee was using a table saw to cut a piece of wood for wall framing. The wood jumped, causing the employee's hand to move toward the saw, amputating their left index finger and causing a laceration on their hand.
An employee was operating a trim saw. While trying to free a jammed board she had just cut, she came into contact with the running saw blade, which amputated her right thumb.
An employee was unloading frameless mirrors from a trailer. When unstrapped, the mirrors fell over onto the employee, who suffered a skull fracture, a brain bleed and blood clot, a broken left ankle, and lacerations.
An employee was drilling a hole into the sealed hold of a vessel so a marine chemist could test its atmosphere. Upon drilling the hole, a gas that was under pressure was released and caught fire at the drill motor, where the employee was holding it. The employee was burned.
An employee was inspecting the attic in a home. The employee stepped off the drop-down attic ladder onto drywall, fell through, and landed on the floor about 10 feet below. He suffered a broken left tibia.
An employee went aloft in a bucket truck to install a rubber cover-up for the pole set. He was proceeding to frame and transfer the conductors to the new pole when he sustained electrical burns on his left side, arm, and leg that required hospitalization.
An employee was positioned on a scaffold. They were using a level to adjust a pole and place bricks on the side of a wall. They fell approximately 30 feet from the scaffold to the ground, resulting in fractures to their back, rib, and heel.
An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.
An employee was walking past a crossover conveyor when a ramp came down and hit them in the back. The employee sustained a broken back vertebra, as well as a concussion, and was hospitalized.
An employee was using a hook tool to pull a pallet onto the lift gate of a tractor trailer. The hook detached from the underside of the pallet, causing the employee to fall backward off the lift gate. The employee landed on the concrete parking lot about 5 feet below, suffering fractures to the skull and two thoracic vertebrae.
An employee was walking on a truss table when he lost his balance and fell approximately 3 feet to the floor. The employee sustained a dislocated and fractured left ankle.