Freeport McMoran

An employee was removing a roll from a copper rolling process using a handheld hydraulic press. The press caught the employee's finger, pinching off the fatty part of the employee's finger.

An employee was changing mud cups in the hopper cylinders of a concrete pump truck. The cylinders moved and three of the employees fingers were amputated.

An employee was standing on the rig floor next to a polishing unit. His hand was placed on the polishing unit when the pump was lowered, resulting in amputation of their right thumb, ring, and middle fingertips.

An employee was using air to blow out the air wash to the blender and grinder station. As the employee reached to verify that the air wash was clean, the unit pinched and amputated their fingertip.

An employee was retrieving a lost drill pipe with a lifting bail when their left thumb got pinched between the table and handle of the lifting bail while trying to re-thread the pipe to lift it out. The employee suffered an amputation to the left thumb.

An employee was removing a core chuck from a stationary roll when their right ring finger was pinched between the chuck and the roll. The employee's fingertip was amputated.

An employee had been cleaning the work area. While lifting a saw, the employee's index finger was lacerated by the saw blade. A tendon was cut and required surgery.

An employee was delivering home heating fuel when bees came from the ground and stung the employee's face, neck, torso, and hands. The employee proceeded to shut off the oil flow before losing consciousness. They were hospitalized due to an anaphylactic reaction.

An employee was using a torch to loosen a bolt on a water trailer. Natural gas was present in the water and it ignited, causing a fire. The employee sustained third-degree burns to their upper leg.

An employee had been conducting crane operations. The employee went to stop a piece of oil and gas equipment for tubular running from falling over to the ground. Their right hand was caught between a rolling ladder and the equipment, resulting in fractures to the index and middle fingers. They were hospitalized and the middle finger required surgery.

An employee was working to install a drive belt on a water pump. He was holding the belt on both sides of the pulley, working to route it over the top. As he pulled down with his right hand, the pulley rotated and the belt slid over it, pulling his left little finger between the pulley and the belt. He suffered an amputation to the fingertip as well as a fracture to the ring finger.

On September 25, 2025, an employee climbed an aluminum extension ladder and was on top of the roof of a building She was walking around on the roof, inspecting and evaluating it. She was descending the ladder when the ladder slid to the right and twisted around as she hung onto it. She then fell 10-12 feet to the paved parking lot and the ladder landed on top of her. She sustained a fractured left collarbone, multiple other fractures, and had bruising to the left side of her abdomen.

At about 5:55 p.m. on August 9, 2025, an employee lost his footing while climbing an access ladder to a 12-foot-high spotlight platform. He fell about 9 feet to the ground, breaking eight ribs on the right side.

On August 1, 2025, an employee was preparing to initiate canine training when they were bitten by a dog on the neck and face.

An employee was completing an annual work capacity test. Later that night, the employee experienced severe pain in their left leg and was hospitalized with rhabdomyolysis and compartment syndrome in the lower left leg.

An employee was setting chains to secure a concrete barrier to a front-end loader. The chain became twisted and lost slack. The concrete barricade fell on the employee's left foot, causing a partial amputation to a toe.