Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Bureau of Reclamation-Grand Coulee Dam, Highway 155, GRAND COULEE, WASHINGTON 99133
on — Amputations, affecting the finger(s), fingernail(s), unspecified.
Final narrative
An employee was grinding a gusset plate with a disc grinder when the gusset got caught, pulling the employee's finger into the machine. The employee sustained an amputation to the right index finger.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 221111)
An employee contracted by another company was conducting work on the platform of the plane train when he fell off the platform, resulting in a fracture and contusion to his face.
Two employees were setting up an inspection camera over a manhole. One of them tripped and fell into the manhole, landing about 20 feet below and suffering a broken left ankle, a sprained right ankle, and a laceration to the back of the skull. He was hospitalized.
On 11/9/2023, an employee on an extension ladder was reconnecting power to a residential meter pole. The wooden pole shifted and caused the employee to fall from the ladder to the ground. The employee sustained a fractured right tibia.
An employee was on a ladder re-routing electric service meter equipment. As they were removing the old service from the meter, the employee slipped from the ladder and landed approximately 5 feet below on concrete. The employee sustained broken bones in the lower left leg.
An employee was working as a field service representative for a grocery store. The employee slipped on a wet floor in the grocery store and fell, fracturing her tailbone.
An employee was drilling a hole into the sealed hold of a vessel so a marine chemist could test its atmosphere. Upon drilling the hole, a gas that was under pressure was released and caught fire at the drill motor, where the employee was holding it. The employee was burned.
An employee was performing restoration activities outside a 45-gallon condensation tank of a boiler system. As they were performing post-maintenance activities after repairing one of the two discharge pumps, one of the discharge valves would not open. The employee closed the intake pump to cool off the system and open the discharge valve. Two employees opened the inlet valve to return the tank to service. After they cracked open the inlet valve, a side wall of the tank blew out, causing the injured employee to suffer steam burns to half their body.
An employee was testing and troubleshooting the gang cylinder valve located in the gang area of the sawmill. The employee's fingertip was amputated by the gang cylinder valve.
An employee was unlocking containers on deck. The employee was de-lashing while standing on the edge of the lid. The lashing bar he was holding came off the cone, causing him to turn 90 degrees and strike a railing behind him. The employee sustained four fractured ribs.
An employee parked a side-by-side on the fixed internal ramp aboard a cargo ship. They exited the side-by-side and went to inspect the cargo below. The side-by-side rolled toward the employee and struck them as they were walking toward the edge of the ramp. The employee was knocked off the ramp and landed on the lower deck approximately 8 feet below. The employee was hospitalized with a fractured shoulder.