Struck against moving part of machinery or equipment · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Archer Daniels Midland Company, 4666 Faries Parkway, DECATUR, ILLINOIS 62526
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
On January 8, 2023, at approximately 2:20 AM, an employee was accessing a drag conveyor when his right hand contacted the running conveyor. He sustained amputation of his right index and middle fingers.
On April 27, 2025, employees were performing a railcar switch. When the train began to shift back, the injured employee's right arm got crushed between the knuckles of two railcars. The employee was hospitalized with fractures to their forearm.
On August 7, 2022, at about 12:30 PM, an employee was working to open a gate at the bottom of a railcar when they were struck in the face with a metal prybar. This resulted in a laceration below the right eye, and an injury to the right eye that required surgery and hospitalization.
On August 30, 2021, an employee was opening the door to a pallet magazine while operating a forklift. As the employee backed up the forklift, the employee's fingers were pinched between its frame and the magazine door. The employee suffered a fingertip amputation.
An employee was on the ground by a railcar attempting to unplug an oil line to allow the oil to flow from the railcar to a tank in the facility. Oil splashed out of the top of the railcar and landed on the employee causing burns to the top of the employee's shoulders.
An employee was operating a strip saw. As the employee shut off the saw, their right index and middle fingertips were amputated by the blade before it came to a complete stop.
An employee was using a table saw to cut a piece of wood for wall framing. The wood jumped, causing the employee's hand to move toward the saw, amputating their left index finger and causing a laceration on their hand.
An employee was operating a trim saw. While trying to free a jammed board she had just cut, she came into contact with the running saw blade, which amputated her right thumb.
An employee was working on removing the gearbox from the drive shaft of the motor assembly of a feather drier. He was using a hydraulic tool to pull the pieces apart when a bolt dislodged from the eye of the gearbox and the corner of the gearbox broke off. The employee was struck in the nose (sinus cavity), resulting in hospitalization and surgery.
An employee was on a forklift checking the sprinkler system drain. The employee fell 8 feet from the forklift to the floor. The employee suffered a broken collar bone and was hospitalized.
An employee was working as a dumper on a packaging line. A passing forklift turned and pinned the employee against a guardrail. The employee suffered fractures to their ribs and a leg requiring hospitalization.
An employee was cleaning an upper mezzanine. When he leaned against the mezzanine gate, he fell through the gate opening and landed 11 feet below. The employee sustained fractured orbital bones.
An employee was assigned to clean a feed mill in the basement. He then rode a tool and material basket to return from the basement to the ground level. He fell out of the basket and landed about 5 feet below. The employee sustained fractures to his arm, lower back, and foot.
An employee was changing a die in a press when the die slipped and crushed the employee's left index finger. The employee sustained an open facture of the tuft of the left distal phalanx and a partial amputation.
An employee was driving a boom lift (in the lowered position) in an exterior dock area. The lift s left wheels rolled onto base plates that covered a 3-foot-deep sump pit. The base plates failed, and one side of the lift dropped. The employee's left leg was caught under the lift basket, and he suffered a fracture to the lower leg including the ankle.