Injection Works

An employee was using a saw to cut a piece of concrete when the piece gave way and pushed the saw into the employee's leg. The employee's leg was lacerated, requiring stitches and hospitalization.

An employee was using a utility knife to cut honeycomb paper when the knife amputated their left index fingertip.

An employee was cleaning a resident's chimney. While using a drill, the employee's glove became caught in the drill and their finger was fractured.

An employee was grinding some hardfacing on a bulldozer blade when the 9-inch grinder kicked back and lacerated his left leg above the knee. The employee was hospitalized and required surgery.

An employee was operating a rotating tool to place thread protectors on the end of pipe. Her left hand was on the rotating part of the tool when the tool engaged, resulting in a left forearm fracture and a thumb laceration.

An employee was completing setup of a job on a plastic molding machine. The employee was moving a molding tool within the machine using an overhead crane. Their left middle finger was caught between the molding tool and the eye bolt resulting in a fingertip amputation.

An employee was moving a piece of molding equipment on a pallet using a pallet jack. The molding equipment tipped over and pinched the employee's middle finger, resulting in a partial amputation without bone loss.

The employee was working with a plastic lid press machine used for installing lids on cooler products. The employee was clearing a stuck plastic lid and their hand was caught in a pinch point resulting in a partial amputation to a finger.

An employee was performing maintenance on a clean-in-place (CIP) machine when the tip of the employee's thumb was caught in a pinch point and amputated.

On 04/25/2019, at approximately 5:27 p.m., an employee was adding rubber to the top of an extruder when the employee's right hand contacted the auger that was below the rollers. All four fingers on the employee's right hand were surgically amputated.

An employee tripped over a stool and fell on the floor, resulting in a left displaced mid-cervical femoral neck fracture.

An employee was installing fence posts when they stepped into a recently dug hole that was not visible due to rainfall. The employee's leg was fractured.

An employee assisted in cleaning material from a conveyor pit. After the pit was cleaned, the employee proceeded to replace metal safety plates to ensure other employees did not fall into the pit. While replacing one of the last plates, the employee mis-stepped and fell approximately 5 feet into the pit. The employee was hospitalized with back/side bruising, elbow bruising, bone bruises, and/or fractured ribs.

An employee was inspecting a breaker box and turning on/off a circuit breaker when he was electrocuted.

An employee was walking on the sidewalk. When they stepped off the curb, they fell to the ground, resulting in fractures to their tibia, fibula, and a metatarsal.