Ignition of vapors, gases, or liquids · Heat (thermal) burns, unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at YANCEY BROS. CO., 1465 E. Highway 80, POOLER, GEORGIA 31322
on — Heat (thermal) burns, unspecified, affecting the hand(s), unspecified.
Final narrative
An employee was troubleshooting a connection on a dozer when aerosol fluid ignited, due to an electrical arc from exposed wire. The employee sustained burns to their hands.
HospitalizedHand(s), unspecifiedChemicals and chemical products, unspecified
An employee was performing maintenance on a school bus. After completing the repair, they went to close the garage door using the manual chain mechanism. During this process, the garage door came off its tracks and fell, striking the employee. The employee sustained a laceration to the head and a fractured left femur.
On November 15, 2024, an employee was operating a hydraulic press and ejecting metal when a piece of metal struck the employee in the face, causing fractures to their nose and maxilla.
An employee brought two scissor lifts to a new construction warehouse, and was documenting the completion of delivery by taking pictures. The employee walked backward to get a wider angle and stepped off the loading dock, falling about 46 inches to the concrete ground outside the loading dock. The employee's right elbow was fractured.
An employee was using a chisel and hammer to separate and remove a bearing in the axle of a road scraper machine. One of the tools struck his left thumb, resulting in the partial amputation of the thumb tip at the end of the nail.
An employee was cleaning a cordless drill. As they applied brake fluid to the drill and pulled the trigger, the fluid ignited. The employee suffered burns to the face, hands, and arms.
An employee was spraying glue to the floor of an enclosed cargo trailer. The fumes made contact with the heater causing a flash fire. The employee suffered burns to their face and right hand.
An employee was replacing a valve in the gas line to the fryer. The shutoff valve malfunctioned resulting in a gas leak that then ignited. The employee sustained burns requiring hospitalization.
An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.
An employee was climbing a ladder to inspect a vent in a restaurant dining area. The ladder slid out on the floor and the employee fell approximately 12 feet onto the ladder and the floor. He was hospitalized with a dislocated shoulder and a back injury.
An employee was operating a lift truck when it struck a stationary lift truck. His left thumb was pinched between the two lift trucks, resulting in a partial amputation.
An employee was disassembling a pressurized unit using a driver drill. When the unit was disassembled, it caused a kickback from the tube head, causing the drill to strike the employee's left forearm. They sustained a diaphyseal fracture to their left radius and ulna, which required surgery.
After repairing a piece of industrial equipment, an employee had brake-cleaning liquid on his gloves. A lighter ignited the liquid, and the employee's hands were severely burned.
An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.
During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.
An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.