Struck against stationary object or equipment, n.e.c. · Cuts, lacerations
At a glance
Federal OSHA recorded a severe workplace injury
at Penn Machine Company LLC, 106 Station Street, JOHNSTOWN, PENNSYLVANIA 15905
on — Cuts, lacerations, affecting the wrist(s).
Final narrative
An employee was preparing to remove parts from a CNC milling machine. He was using a combination wrench to loosen the hold down clamps when his hand slipped and his supporting arm contacted a sharp surface on the work piece he had just created. The employee sustained a laceration on his left wrist about an inch below the palm of his hand.
HospitalizedWrist(s)Parts and materials, unspecified
An employee was unnesting tote bags when her grip slipped and the back of her left hand hit a box containing a steel step stool that was adjacent to the tote bags. The employee's hand was fractured.
An employee was cleaning up and putting away equipment when the second toe on her right foot was stubbed on a fixture, resulting in hospitalization and a subsequent amputation of the toe.
An employee was walking when he tripped on a concrete vault lid, jamming his big toe into the tip of his steel toe boots. The employee's big toe was medically amputated.
An employee was cleaning a bathroom. As the employee bent over, the corner of a sink hit the employee's right eyeball, causing an injury that required hospitalization and surgery.
On September 23, 2023, an employee was cleaning near a conveyor when they knelt with their right knee on the floor. Their knee contacted a small piece of glass on the floor, resulting in a laceration that required hospitalization.
More severe injuries in this industry (NAICS 332710)
An employee was positioning dunnage on a trailer while pipe was unloaded from a forklift. A pipe fell and the employee's right thumb and index finger were caught between the pipe and a piece of dunnage. The thumb was crushed, and the index fingertip was amputated.
An employee was using a lifting sling on a crane to move a straight-bar bundle and place it on top of an existing bundle. When moving the lifting sling, it became pinched between the bundle and a wood cleat. The bundle then fell onto the employee's left foot, resulting in crush injuries.
An employee was stacking metal tubes using a forklift. A stack became unstable and the employee got out of the forklift to steady it, instructing his helper to get into the forklift. The forklift movement caused some tubes to fall and strike the employee, resulting in an open fracture of his left hand.
An employee was setting up a flexible gear coupling hub in a lathe, preparing to bore it out to fit a shaft. The hub assembly was not secured in the chuck when the crane support was removed, and the employee's right little finger was caught between the hub assembly and the inside of the lathe. The fingertip was amputated.
An employee was using a crowbar to loosen a flat bar when the crowbar struck the employee's right eye. The employee was hospitalized and required surgery.
An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.
An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.
An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.
An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.