Vehicle or machinery fire · Second degree heat (thermal) burns
At a glance
Federal OSHA recorded a severe workplace injury
at Oasis Systems, NUWC Seneca Lake, DRESDEN, NEW YORK 14441
on — Second degree heat (thermal) burns, affecting the hand(s), unspecified.
Final narrative
Employees were inside a building, replacing the fuel filler hose on a boat. The fuel filler hose runs down the port side of the boat and under the deck to the fuel tank which is mounted in the center of the hull. The employees used an electric heat gun to soften the thick rubber hose to allow for installation. A flash fire occurred in the gasoline fuel tank on the boat. An employee sustained first-degree burns to the face and second-degree burns to both hands. The employee was hospitalized.
An employee removed the spark plugs and was rotating an engine to evacuate condensate from the cylinders. An unknown source ignited the condensate and natural gas. The employee sustained burns to the back of his hands and upper leg area.
An employee was operating a front-end loader when a hydraulic line broke, causing the front-end loader to catch on fire. The employee jumped from the cab to the ground and sustained fractures to the T-6 vertebra and a heel.
An employee was moving two totes of turpentine. Noticing that one of them was leaking, he stopped his forklift and began to look for the leak. The forklift caught fire, and the employee suffered severe burns. He was hospitalized.
An employee was performing maintenance on a machine when part of an adjacent machine caught fire. The employee extinguished the fire and suffered smoke inhalation.
More severe injuries in this industry (NAICS 541330)
An employee was working to free a load by grabbing and shaking the live side of a tugger line. Once the load became free and progressed upward, the employee's hand was caught and pulled into a snatch block. The employee's right thumb was broken and lacerated. The employee was hospitalized and required a surgical amputation.
An employee was operating a drill rig when when their hand got caught between a 1/4-inch steel cable and a drill rod, resulting in the amputation of four fingers.
An employee was overseeing the operation of a rope being respooled onto the drum of a wire winding machine. He went to remove a piece of wooden reel from the rope. His glove got snagged and his right hand was pulled into the roller, pinching his fingers between the machine's roller and the rope. The middle and index fingers were crushed.
An employee was visiting a patient's home to fit them with a wearable cardiac defibrillator. As he was walking from the front door to his car, a large dog broke free from a chain and attacked him. He was bitten on the forearm and fell. The patient was then able to restrain the dog. The employee was hospitalized with severe dog bites and required surgery.
An employee tripped over a junior I-beam about 4 feet long and 6 inches tall that was installed for circulating water valves and fell to the ground, resulting in a broken right-side rib.
An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.
An employee slipped while descending in a stairwell, fell, and suffered multiple contusions/bruises to the head, neck, shoulders, knees, and back. She was hospitalized.
An employee was directing trucks as they entered and left a highway work zone. A vehicle struck them, resulting in multiple fractures and other injuries. The employee was hospitalized.