Federal OSHA recorded a severe workplace injury
at COMMERCIAL FLOOR RESOURCES, LLC, 5220 Jimmy Lee Smith Parkway, HIRAM, GEORGIA 30141
on — Amputations, affecting the finger(s), fingernail(s), unspecified.
Final narrative
An employee used a forklift to take a trash hopper to the dumpster. While driving back from the dumpster, the cord that had been used to open the hopper handle got caught under a wheel of the forklift causing the cord to tighten around the employee's left hand. The employee sustained amputation to the index, middle, and ring fingers.
AmputationFinger(s), fingernail(s), unspecifiedForklift, order picker, platform truck-powered
An employee was using a dozer to clear a plot of land. The dozer struck the ground after getting stuck on a tree stump, causing the employee to hit their head on the cab roof. The employee sustained a spinal compression injury.
On August 31, 2023, an employee was operating an excavator to complete a demolition job. As the excavator drove into the first floor of the building, the floor collapsed. The vehicle and employee dropped approximately 8 feet, causing the employee to sustain a back injury.
An employee was standing on a walk-behind lawn mower when the mower spun out of control. His right ring fingertip became caught in the handlebar, resulting in an amputation.
An employee was loading a bundle of 3/8-inch rebar using a standup skid loader. While transporting the load, the equipment tipped forward, throwing the employee over the controls and into the mast of the skid loader. The employee sustained several teeth avulsions, a mouth laceration, and bruising/swelling around the face.
An employee was driving a forklift to deliver lumber to a work site when the forklift tipped forward onto the forks. The employee struck his head on a metal railing on the forklift, resulting in a laceration, a concussion, and temporary loss of consciousness.
More severe injuries in this industry (NAICS 423440)
An employee was using a powered pallet jack. As he was maneuvering backward, his right foot slipped, causing the pallet jack to pin his right leg against a rack. He suffered a laceration between his ankle and his calf, as well as a fracture, and was hospitalized.
An employee was operating a high-density polyethylene (HDPE) fusion machine. The machine's carriage was directing a fitting that was being lifted from the machine when the employee's left ring finger was crushed in a pinch point, resulting in a fingertip amputation.
An employee was struck by a semi truck and pinned against a forklift while performing unloading activities. The employee was hospitalized with broken ribs and a torn left MCL.
An employee was on top of a railcar and was using a rod to push out some resin that had become lodged inside of the car. When he lifted the rod, it contacted a live, overhead wire and he was electrocuted. The employee sustained burns to 12-20 percent of their body.
An employee was walking to the processing area when she was struck by a forklift carrying stacked pallets. The employee fell to the floor. The forklift then reversed with the employee caught on the pallet, causing her to be dragged by the vehicle. She sustained a fractured left ankle.
An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.
During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.
An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.