Five P Drilling, Inc.

An employee was performing an inspection of the seed warehouse when they fell 30 feet from a catwalk to the ground. The employee sustained facial injuries and a compound fracture to the left femur.

An employee was on a cherry picker approximately 30 feet high, selecting boxes of merchandise from warehouse racking to place onto a pallet. The employee fell and sustained neck and back injuries.

On November 6, 2023, an employee was installing roofing materials on a multi-residential construction site 35 feet above ground level. The anchor on the employee's personal fall arrest system became unattached and the employee fell to the ground. They sustained multiple fractures.

On October 12, 2023, an employee was stacking insulation on a roof when they fell 35 feet through a skylight to the concrete floor below. The employee sustained an ankle and pelvis fracture.

On the fifth or sixth floor deck, an employee was supervising iron workers who were measuring to place rebar. The employee was struck by a wooden tool box that was being lifted by a tower crane. The employee then struck a wooden fence and fell approximately 50 feet to the ground. The employee sustained fractures to both legs and lacerations.

An employee was stepping down off a 6-inch containment platform to finish loading his truck, when his right ankle rolled. The employee sustained a fractured tibia and fibula at the right ankle and required surgery.

A service crew was pulling a pump and motor from a well. After breaking a joint of pipe loose from another joint, an employee grabbed the chain tongs to prevent the pipe from spinning in the well, so the crew could continue taking it apart. The bolt that attaches the chain to the handle of the chain tongs broke, causing the chain to swing around and strike the employee's lower right leg. The chain severely punctured his leg and fractured his tibia.

An employee was working to remove a stuck fish tool from a drill shoe. Their thumb was struck by a hammer, resulting in amputation.

An employee arrived on location and loaded a blow-out-preventer (BOP) on a 1-ton flatbed truck. While standing on the flatbed securing the the BOP, the employee stepped into a void/hole on the flatbed surface. This caused him to lose balance and fall off the truck bed with his leg still caught in the hole. As a result, he sustained fractures to his left leg.

An employee was rigging up a location. He was using an Allen wrench to free up rotation and start the drawworks engine manually. The engine rotated and his left little finger became caught between the Allen wrench and the engine. The employee sustained an amputation to his little finger and fractures to his wrist.

An employee fell while moving a water canister, resulting in fractures to four fingers on her right hand.

An employee was changing a die in a press when the die slipped and crushed the employee's left index finger. The employee sustained an open facture of the tuft of the left distal phalanx and a partial amputation.

An employee was mixing sauce using a sauce barrel mixer when his left little finger was amputated.

An employee was driving a boom lift (in the lowered position) in an exterior dock area. The lift s left wheels rolled onto base plates that covered a 3-foot-deep sump pit. The base plates failed, and one side of the lift dropped. The employee's left leg was caught under the lift basket, and he suffered a fracture to the lower leg including the ankle.

A temporary employee was carrying a nail gun through the warehouse when it hit his leg, activated, and fired a nail into the leg.