Direct exposure to electricity, unspecified · Electrical burns, unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at Renmatix, Inc., 679 Ellsworth Road, ROME, NEW YORK 13441
on — Electrical burns, unspecified, affecting the chest, except internal location of diseases or disorders.
Watch Renmatix, Inc. — freeGet an email when a new federal OSHA severe-injury report for Renmatix, Inc. is published. One employer, no account, unsubscribe in one click.
Final narrative
An employee was welding a pipe. The welding filler rod and vise grips became stuck. When the employee freed them, they made contact with the employee's chest, causing electrical burns.
HospitalizedChest, except internal location of diseases or disordersWelding, cutting, and blow torches
An employee was installing a 15-amp breaker in an electrical panel when a 12-gauge ground wire touched the positive busbar of the panel, resulting in an arc flash. The employee sustained a second-degree burn to their left hand.
An employee was repairing an HVAC system in the drop tile ceiling of a conference room when they were shocked, causing them to fall from the ladder. The employee sustained burns to their right middle and ring fingers.
An employee was replacing a contactor inside an electrical panel attached directly to a press. The press itself was receiving power from another main panel. After replacing the contactor, the employee flipped the switch and an arc flash occurred, burning the employee's elbow, bicep, and neck.
An employee was attempting to switch a medium-voltage primary cable and install a 200-amp fuse barrel. The employee contacted the bottom of the switch gear cradle for the fuse barrel, causing an arc blast. The electricity entered the employee s left hand and exited his big toes, resulting in electric shock and burns to the left hand, arm, shoulder, and both feet. The employee was hospitalized.
On December 6, 2023, an employee of Duke Energy was working on a single-phase 120-/240-volt parallel service re-tap when a secondary flash occurred in an underground service. The employee suffered a second-degree burn to the face and was hospitalized.
More severe injuries in this industry (NAICS 325193)
An employee was backing up a forklift when the frame of the forklift clipped the wall. The employee's right little finger was pinched between the wall and the forklift, resulting in amputation.
An employee was removing contaminants from a low point drain on an ammonia line through a hose and into a container of water. A release of pressure from the end of the hose exposed the employee to anhydrous ammonia, resulting in chemical burns to his face, arm, and chest as well as ammonia inhalation. He was hospitalized.
At about 7:00 a.m. on February 11, 2025, an employee was troubleshooting a system that had failed to start. Suspecting a tripped breaker and intending to test the system's motor leads, he hooked up an insulation resistance tester. The side of the breaker the tester was hooked up to was still energized, resulting in an arc flash. The employee was hospitalized with second-degree burns to his face and right arm.
An employee was preparing hopper rail cars for loading. The employee fell from the platform used to access the rail car lids, landing in an empty hopper and suffering broken ribs.
An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.
An employee slipped while descending in a stairwell, fell, and suffered multiple contusions/bruises to the head, neck, shoulders, knees, and back. She was hospitalized.
An employee was directing trucks as they entered and left a highway work zone. A vehicle struck them, resulting in multiple fractures and other injuries. The employee was hospitalized.