Fall or jump from and struck by same vehicle in normal operation, nonroadway · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at CONGLOBAL INDUSTRIES INC, 32880 west 191st street, EDGERTON, KANSAS 66021
on — Fractures, affecting the leg(s), unspecified.
Final narrative
An employee was operating a mobile cart in a designated pass location between railroad tracks. The cart became stuck, then tipped over as the employee tried to release it by maneuvering it. It broke both the employee's legs and crushed their feet.
HospitalizedLeg(s), unspecifiedIndustrial vehicle, material hauling and transport-powered, n.e.c
An employee was driving a double pallet jack down an aisle when another piece of equipment came through the aisle. Realizing that the two pieces of equipment were about to collide, the employee jumped off the pallet jack. It then ran over his leg, breaking his leg/ankle.
An employee was operating a forklift when the load shifted. The employee jumped from the forklift and it rolled backward, falling off the ramp and pinning the employee underneath it. They sustained head trauma and injuries to the shoulder, arm, pelvis, and leg.
An employee was operating a rider-style powered pallet jack. He lost his balance causing him to fall off and become trapped between it and a wall. He suffered a broken pelvis and was hospitalized.
An employee was operating a stand-on mower down a hill when the mower started sliding. The employee jumped off the mower and fell to the ground. Their hand was cut by the mower blade, resulting in a laceration and a thumb amputation.
An employee was driving a package car around a building on UPS property when the vehicle struck a bump. The force from hitting the bump unbuckled the employee's seatbelt and caused them to fall out of the vehicle onto the asphalt. The employee was hospitalized and required surgery for fractures to their hip and pelvis.
More severe injuries in this industry (NAICS 333924)
An employee was using a punch and hammer to remove a pin from the mast of a forklift. The mast was secured by an overhead crane. The mast shifted, and the employee's thumb was pinched between the mast and the punch, resulting in an amputation to the tip of his left thumb.
On September 22, 2025, an employee tripped and fell over a permanent fixture (angle iron) that serves as a parking block in the back of a facility. He suffered a fractured right hip and was hospitalized.
An employee was helping a customer with repairs on their trailer. While lowering the ramp door of the trailer, the customer dropped the door and it contacted the employee's left ring finger, resulting in a fingertip amputation.
An employee was working to lay a part in the vise of the band saw in preparation for cutting. The left vise closed, pinching his fingertips against the part. The employee's middle and ring fingertips were amputated and they sustained a laceration to the index finger requiring stitches.
An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.
An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.
An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.
Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.
An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.