Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Parts Authority, 1292 Hammond Street, BANGOR, MAINE 04401
on — Amputations, affecting the finger(s), fingernail(s), unspecified.
Final narrative
An employee was using a chop saw to cut a one-eighth inch wire cable. The wire became entangled with the saw and the cable was pulled in. The employee's fingers were caught in the cable, resulting in partial amputations to the left index, ring, and little finger.
An employee was picking parts for an order when he fell about 8 feet off the end of a mezzanine onto an empty wooden pallet on the floor below. He was hospitalized for a severe concussion, a fractured rib and multiple lacerations.
An employee was working in an elevated platform (cherry picker) that stopped working. A coworker came to rescue him, and as he stepped off one platform onto the other, he slipped and struck his head. He was working 10 feet above the lower level and was wearing a body harness and retractable lanyard at the time.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 441310)
An employee was carrying a plastic tote full of brake rotors. His foot caught the corner of a pallet, causing him to fall to the concrete floor and break his hip.
An employee was working on a vehicle in a bay. As he turned around, his foot caught on the leg of a lift and he heard/felt a snap and pop in his right hip and fell. The employee sustained a torn hamstring in his right leg.
An employee was installing a driveshaft on a customer's vehicle. He was using a floor jack to hold the driveshaft in place to line up the bolts. The driveshaft moved off the jack and crushed his left ring fingertip, resulting in an open fracture of the tuft of the distal phalanx, as well as a partial amputation.
An employee was in a truck, helping a team lift a 55-gallon drum into the truck. The employee fell to the ground and suffered a broken left arm. The employee was hospitalized and required surgery.
A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.
Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.
An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.
An employee was standing on a step stool, removing the nuts and bolts from the frame of a solar panel that was being replaced. The employee's cheek made contact with a connector with damaged insulation. The employee was shocked, briefly lost consciousness, and fell to the ground, suffering an injury to the left shoulder.