Pinnacle Pest Management Service

A crew was working near an electrical pole. A co-worker was using a front-loader to grade a slope when the loader slid into a guy-wire and became tangled and stuck. The injured employee used a handheld grinder to cut the wire a few feet from the ground. The lower part of the wire fell to the ground, but the upper part of the wire fell toward the pole and contacted an energized part before the end landed in nearby bushes. The employee attempted to shake the bush to free the wire so it could fall back toward the pole. The wire popped up and contacted his hands, resulting in electrical entry burns to both hands and exit burns on both feet.

On November 18, 2023, two employees were using a 2x4 to lift a power line. The boom lift they were operating made contact with power lines and both employees sustained electrical shock injuries.

An employee was part of a crew that was servicing a power line. The employee was in a bucket truck when he contacted the 7,200-volt power line. The electricity entered through one hand and exited the other, causing several electrical burns. The employee was not wearing proper personal protective equipment at the time.

An employee was helping a crew set up a 45-foot pole between two other poles. It was being set up between two energized lines and the pole made contact with the A-phase. The employee was electrocuted and lost consciousness. The electricity also caused an entry wound in their left forearm and an exit wound in their left foot.

An employee was handling a 45-foot long rebar for installation on the third floor of a building at a 30-foot elevation. The rebar came into close proximity of a powerline situated 13 feet off the building. The employee sustained electrical burns to his hands from electric discharge, requiring hospitalization.

The injured employee was trimming a bush with a hedge trimmer. He reached over with his left hand to remove a branch. The blades of the trimmer partially amputated his left index finger.

An employee was performing pest control services at a residential home when he tripped and fell on the front porch steps. The employee was hospitalized with a fractured wrist, two fractured ribs, and a subdural hematoma.

An employee was on a 32-foot fiberglass ladder positioned on a porch roof, using a caulk gun to seal the fascia board around the gable of a house. He was about 16 feet up the ladder, which was not fully extended. The base of the ladder slid away from the house. The employee fell onto the porch roof, then to the ground below, a distance of about 10 feet. He suffered broken ribs, lacerations and facial abrasions, and a potential facial fracture.

An employee was going door-to-door selling pest control services during 80+ degree weather. The employee sustained heat stroke and collapsed.

An employee was performing service on a customer's attic. They stepped off a walk board to retrieve a tool and misstepped onto the rafters, causing them to fall approximately 10 to 12 feet. The employee sustained a back injury.

An employee was helping a coworker transport a tall palm tree with a mini skid steer. The employee was severely shocked by a high-voltage electrical wire above the ground.

An employee was retrieving a Christmas tree from a shelf using a ladder. He missed a step and fell to the concrete floor. He sustained injury to his head and wrist.

An employee was inspecting a generator whose radiator was leaking. He slipped, and a fan blade in the generator amputated his thumb and index finger.

An employee was operating an agricultural tractor during sugarcane harvesting. The employee sustained a lumbar sprain due to vibration or motion from the tractor.

An employee was moving a 3-ton condensing unit, strapped down on a dolly, out of a garage. The strap broke, causing the employee to fall backward onto the brick pavered driveway. The employee suffered injury to a spinal ligament in the neck.