ClearWell Well Services, LLC

Employees were rigging down a power swivel at a well site. They placed the power swivel in a trailer and were preparing to remove the Kelly valve and cross-over subs. The operator came down from the drillers console, set the power swivel's control panel down in front of the draw works, and then went to get a kink out of a hydraulic hose. The hose caused the control panel to flip over, engaging the power swivel. The injured employee placed a 48" pipe wrench onto a sub. When the power swivel engaged, the wrench swung and struck the injured employee's left knee. The employee's knee was dislocated and they sustained soft tissue damage to the ACL and MCL.

An employee was assisting with the rig down of tubing testing equipment when the end of one of the tool joints with a winch line broke. A small section swung back toward the rig floor and hit the employee in the upper back, causing a contusion on the spine. The employee was hospitalized.

An employee was adjusting the operator console to raise it to a higher level. He removed the bracket that connects the console to the rail system so he could begin raising it. The console shifted, causing the employee to fall 10 feet, resulting in a shoulder fracture and head laceration.

An employee was installing a wiper rubber on tubing before pulling the tubing out of a well. His right ring finger was caught between two pieces of metal on the tubing tongs, and the fingertip was amputated.

An employee was cleaning off a pallet sorting machine. The employee jumped approximately two feet from the top of the pallet sorting machine to a lower platform. Upon landing, the employee's left ankle rolled, resulting in a fracture that required hospitalization.

An employee was working from the forth rung of an 8-foot step ladder installing radiator covers when the cover began to fall. The employee lost balance and jumped from the ladder, landing on his feet and sustaining a heel fracture.

An employee was standing on their flatbed truck adjusting a cargo pallet. He pulled one of the pallet boards and the board broke, causing the employee to lose his balance and jump 4 feet off the flatbed. The employee landed on a concrete surface and sustained a fractured left heel that required surgery.

An employee was cleaning a single screen machine that had been jammed by a garden hose. The employee exited the machine onto the belt guard and jumped from the belt guard to the ground three feet below. When he landed, he broke his left femur.

An employee was walking down stairs when they lost their balance and jumped three feet to the ground. The employee sustained two ankle fractures.

An employee had been cleaning the work area. While lifting a saw, the employee's index finger was lacerated by the saw blade. A tendon was cut and required surgery.

An employee was delivering home heating fuel when bees came from the ground and stung the employee's face, neck, torso, and hands. The employee proceeded to shut off the oil flow before losing consciousness. They were hospitalized due to an anaphylactic reaction.

An employee was using a torch to loosen a bolt on a water trailer. Natural gas was present in the water and it ignited, causing a fire. The employee sustained third-degree burns to their upper leg.

An employee had been conducting crane operations. The employee went to stop a piece of oil and gas equipment for tubular running from falling over to the ground. Their right hand was caught between a rolling ladder and the equipment, resulting in fractures to the index and middle fingers. They were hospitalized and the middle finger required surgery.

An employee was working to install a drive belt on a water pump. He was holding the belt on both sides of the pulley, working to route it over the top. As he pulled down with his right hand, the pulley rotated and the belt slid over it, pulling his left little finger between the pulley and the belt. He suffered an amputation to the fingertip as well as a fracture to the ring finger.

After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.

An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.

An employee was inspecting flares processes. The employee received burns to the front side of the body, face and arm from the flares.

An employee was removing plastic material from a production line when the machine cycled and amputated his left index, ring, and little fingers.

An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.