Other jump to lower level less than 6 feet · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at Rehrig Pacific Company, 32 Earth Conservancy Drive, WILKES BARRE, PENNSYLVANIA 18706
on — Fractures, affecting the ankle(s).
Final narrative
An employee was cleaning off a pallet sorting machine. The employee jumped approximately two feet from the top of the pallet sorting machine to a lower platform. Upon landing, the employee's left ankle rolled, resulting in a fracture that required hospitalization.
HospitalizedAnkle(s)Material and personnel handling machinery, n.e.c.
An employee was moving a stair platform when his left little finger was caught between the platform and a hard surface. The employee sustained a partial amputation of the finger.
An employee was operating the trash can injection mold machine and noticed that the hopper was jammed with plastic material. As the employee attempted to unjam the hopper, the blade amputated the fingertips on his left hand.
An employee was operating a stamping machine and got his right hand caught in the stamper. The employee was hospitalized on 11/18/2015 and underwent surgery to repair fractures on two fingers.
An employee was working from the forth rung of an 8-foot step ladder installing radiator covers when the cover began to fall. The employee lost balance and jumped from the ladder, landing on his feet and sustaining a heel fracture.
An employee was standing on their flatbed truck adjusting a cargo pallet. He pulled one of the pallet boards and the board broke, causing the employee to lose his balance and jump 4 feet off the flatbed. The employee landed on a concrete surface and sustained a fractured left heel that required surgery.
An employee was cleaning a single screen machine that had been jammed by a garden hose. The employee exited the machine onto the belt guard and jumped from the belt guard to the ground three feet below. When he landed, he broke his left femur.
An employee was on a catwalk helping to lay down tubing when he lost his balance. The employee jumped approximately 42 inches to the ground and the 30-foot section of tubing struck his left shin resulting in a fracture that required surgery.
An employee was cutting wood with a miter saw when their clothing was pulled into the blade, resulting in a bicep laceration. The employee was hospitalized. The blade cover was not in place at the time of the incident.
Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.
An employee was processing wood boards at a chop saw when the saw malfunctioned and the blade cut her left hand and fingers. She was hospitalized and her little finger was surgically amputated.
An employee was operating a bubble wrap production line. He was splicing the ends of the film rolls together with tape when a driven roll contacted his hand. His hand and arm were pulled into the machine up to his shoulder. The employee's forearm contacted the the hot surface (230-500 F) of the bubble stamping cylinder. He was hospitalized with burns to the forearm that required surgery and crushing injuries to the hand and forearm without fractures.
An employee was operating a pallet dismantling saw. A board became stuck, and the employee tried to pull the pallet. When the board broke, the employee's right hand made contact with the blade, resulting in the amputation of the right middle finger above the second knuckle.
An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.
An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.
An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.
An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.