Direct exposure to electricity, greater than 220 volts · Electrical burns, unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at Aludyne Columbus, LLC, 1600 Northside Industrial Blvd, COLUMBUS, GEORGIA 31904
on — Electrical burns, unspecified, affecting the multiple trunk locations.
Watch Aludyne Columbus, LLC — freeGet an email when a new federal OSHA severe-injury report for Aludyne Columbus, LLC is published. One employer, no account, unsubscribe in one click.
Final narrative
On August 16, 2023, an employee was addressing a blown fuse on a transformer. He actuated the disconnect above the fuse, removed the fuse, and began removing the middle saddle with a ratchet wrench. The wrench contacted the upper saddle, resulting in an arc that caused the employee to fall to the floor. He sustained severe burns to the chest and abdomen.
An employee was installing a ground wire to a power transmission pole. The ground wire contacted an energized portion of a cut-out, causing an arc-flash. The employee was hospitalized with second degree burns to their chest and arms.
An employee was connecting a utility transformer for underground service to a home. The employee's impact drill went across two connection bars with 240 volts of potential, creating an arc flash. The employee sustained burns to the face and eyes due to the arc flash and molten aluminum.
On December 15, 2023, at 9:15 AM, an employee was changing 60-amp fuses in a 480-volt panel when an arc flash occurred. The employee was hospitalized with burns to both hands.
An employee was changing out the sensor wire on a sensor cap press. The machine actuated after the sensor was replaced, resulting in the amputation of the employee's left little finger.
A temporary employee was working on a plastic extrusion machine. The employee's left index finger got caught between the rotary gears, resulting an amputation to the finger.
An employee in the warehouse area was operating a semi-automated machine and noticed that the machine was not operating properly. He went to use a paper towel to clean the main rollers and his left hand was caught by the rollers. Two fingers were crushed.
An employee was walking to collect trash from a box at a work cell parts stand. A leg of the stand caught the employee's foot, causing the employee to lose balance, fall to the floor, and suffer a broken left elbow.
An employee's leg became entangled in a printer power cord. As she stepped backward, she got hung up and fell. She landed on her right side and suffered a broken right hip.
An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.
During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.
An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.