Alro Steel Corporation

An employee was standing a steel bar on its edge when the bar fell onto his left hand, resulting in a middle fingertip amputation.

An employee was on top of a flatbed trailer moving product around so a forklift operator could retrieve the client's property. The employee tripped over dunnage and fell off the trailer, resulting in rib fractures, disc injuries, and forehead lacerations.

An employee was attempting to retrieve material from a plate saw when the employee's fingers touched a moving blade. Two of the employee's fingers were lacerated.

An employee was moving a round bar stock from the pan to the saw when the bar slipped. The employee grabbed it and their left thumb was crushed between the bar and the saw arm. The employee was hospitalized with a fractured left thumb.

An employee was operating a cold saw and suffered an amputation to the left index finger and part of the middle finger.

An employee was riding on a powered pallet jack near a sewer drain. The pallet jack hit a dip near the sewer drain, and the employee s left foot hit a clamp truck parked in a charging station. He suffered a cut to the big toe, as well as fractures in the toe and the foot.

An employee went to step off material handling equipment to grab their jacket when the throttle of the vehicle engaged. The vehicle reversed and the employee's left foot was crushed between two material handlers, resulting in a fracture.

An employee was working at a height of approximately 20 feet and was standing outside his forklift's basket attachment. His forklift was struck by another forklift, causing the employee to fall to the warehouse floor below. The employee sustained facial injuries, broke two ribs and an arm, and also suffered a head injury. The employee was wearing a harness at the time but it was not connected to an anchor point.

On November 8, 2023, an employee was operating a stand-up pallet jack in the warehouse. As he was backing up, the pallet jack struck the basket of a parked aerial lift. His right ankle became caught between the pallet jack and the aerial lift basket resulting in a fractured ankle.

On October 26, 2023, at approximately 12:00 PM, an employee operating a four wheeler was on their way to an off-property break location. The employee stopped the four wheeler near the administrative office to allow a log truck to exit the property. The log truck backed up, and the employee's left ankle was caught between the log truck trailer and the four wheeler, resulting in a fracture and laceration.

An employee fell from a step ladder while reaching for a tie-off point. He impacted the ground, and landed on his bolt bag which contained tools. The employee was hospitalized with fractured ribs, and a lacerated spleen and kidney.

An employee was attempting to lift a steel beam from a horizontal, stacked position to a vertical position using a crane. They had placed two hooks on the east side of the beam on the flange. As the employee was hoisting the crane, the beam began to shift and pulled the employee forward onto the stack. When the material shifted, the hooks released and the material fell, pinning the employee between the two beams. The employee was hospitalized with soft tissue contusions on their proximal right thigh and interior left thigh.

An employee was standing on the surface of a steel beam about two feet wide. He slipped and fell backward, landing on the concrete ground about 20 feet below. The employee sustained a broken pelvis.

An employee was unloading a rebar delivery from a flatbed, 19-wheel trailer. The employee rigged the load with wire rope chokers. The load was picked up 3-4 feet above the trailer deck by a crane. The load began to swing and the employee grabbed onto it to prevent it from being pushed off the trailer deck. The crane continued to lift the load, and the employee let go so the crane did not lift him to the third story. The employee fell approximately 12 feet to the ground below, resulting in a back injury and fractured vertebrae.

An employee was attaching a steel angle plate weighing (approximately 200 pounds) to the end of a structural member (5,000 pounds) and was supported by dunnage. The dunnage was a crane mat (11 inches tall) with a 4x6 board on top of it and it supported five identical members. The main piece was 30.75 feet long, 37.25 feet tall, and 1 food wide. As the employee slid the piece of metal on top of the member to begin attaching it, the entire member began to tip over. The employee went to stop the main piece from tipping over and it landed on his ankle, fracturing it.

An employee was helping a coworker transport a tall palm tree with a mini skid steer. The employee was severely shocked by a high-voltage electrical wire above the ground.

An employee was retrieving a Christmas tree from a shelf using a ladder. He missed a step and fell to the concrete floor. He sustained injury to his head and wrist.

An employee was inspecting a generator whose radiator was leaking. He slipped, and a fan blade in the generator amputated his thumb and index finger.

An employee was operating an agricultural tractor during sugarcane harvesting. The employee sustained a lumbar sprain due to vibration or motion from the tractor.

An employee was moving a 3-ton condensing unit, strapped down on a dolly, out of a garage. The strap broke, causing the employee to fall backward onto the brick pavered driveway. The employee suffered injury to a spinal ligament in the neck.