Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at HARPER TRUCKS INC., 1522 S. FLORENCE, WICHITA, KANSAS 67209
on — Amputations, affecting the fingertip(s).
Final narrative
An employee was operating a tube bender when their right hand was caught between the tube and the die set. Their middle finger was lacerated and their index fingertip was amputated.
A tooling technician was changing a drill on a drill machine. As he reached into the machine to begin the process, the slide was activated, causing an amputation to his left middle fingertip just before the first joint.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 333924)
An employee was using a punch and hammer to remove a pin from the mast of a forklift. The mast was secured by an overhead crane. The mast shifted, and the employee's thumb was pinched between the mast and the punch, resulting in an amputation to the tip of his left thumb.
On September 22, 2025, an employee tripped and fell over a permanent fixture (angle iron) that serves as a parking block in the back of a facility. He suffered a fractured right hip and was hospitalized.
An employee was helping a customer with repairs on their trailer. While lowering the ramp door of the trailer, the customer dropped the door and it contacted the employee's left ring finger, resulting in a fingertip amputation.
An employee was working to lay a part in the vise of the band saw in preparation for cutting. The left vise closed, pinching his fingertips against the part. The employee's middle and ring fingertips were amputated and they sustained a laceration to the index finger requiring stitches.
An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.
An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.
An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.
Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.
An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.