Caught in running equipment or machinery, unspecified · Soreness, pain, hurt-nonspecified injury
At a glance
Federal OSHA recorded a severe workplace injury
at Teel Plastics, LLC, 1060 Teel Court, BARABOO, WISCONSIN 53913
on — Soreness, pain, hurt-nonspecified injury, affecting the finger(s), fingernail(s), unspecified.
Final narrative
An employee moved a portable vacuum system into place to collect dust from the cutting saw. Their hand was in the exhaust pipe of the vacuum system when their fingers were caught in the impeller.
HospitalizedFinger(s), fingernail(s), unspecifiedWashers, dryers, and cleaning machinery and appliances, n.e.c.
On September 16, 2020, an employee was clearing the bottom tape that had become wrapped around the crusher belt on the bag line. The machine was activated and the employee's left middle finger was caught in the crusher belt resulting in surgical amputation of the fingertip.
On December 19, 2023, an employee was setting up a copper wire drawing machine when his left ring finger was pinched between a copper wire and a machine part. The employee's finger was partially amputated.
An employee was checking the gusset seal on a machine. He moved to the next cross sealer and the machine activated, causing an amputation to a left-hand finger. The employee was hospitalized.
An employee was evaluating a coiling machine to verify that the blade was present inside it. The machine's weld function was activated, and the machine crushed the employee's fingers, resulting in the amputation of the left middle and ring fingers.
At about 11:00 a.m. on August 17, 2025, a Sealer Air Corp. employee suffered a broken right tibia while stepping down from a conveyor to the floor 19 inches below.
An employee was troubleshooting around the secondary draw rollers of a bag machine when their left index, middle, and ring fingers contacted the rollers. The employee sustained a partial fingertip amputation to one of the fingers. The machine was not guarded at the time.
An employee was clearing a jam from the rewinder when their hand was pulled into a rotating part of the machine, fracturing one finger and dislocating another.
An employee was stepping down from a two-step ladder when the ladder slipped out from underneath them. The employee fell and landed on a sidekick trailer jack, resulting in four fractured ribs, including two ribs with multiple breaks, and a pulmonary contusion.
The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.
An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.
A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.
An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.
An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.