Indirect exposure to electricity, greater than 220 volts · Third or fourth degree electrical burns
At a glance
Federal OSHA recorded a severe workplace injury
at DUKE ENERGY FLORIDA, LLC, 13303 Sullivan Road, CLERMONT, FLORIDA 34715
on — Third or fourth degree electrical burns, affecting the multiple body parts, n.e.c..
Final narrative
An employee was changing out insulators and hardware on a lattice 230-kilovolt tower when he saw that the pin that was securing the V-string to the outside phase was falling out. He hooked up a chain hoist to stop it. While going down, the employee dropped the chain hoist, causing it to go by a 69-kilovolt line. He suffered an electric shock by induction, which resulted in third-degree burns on his finger, back, and buttocks.
HospitalizedMultiple body parts, n.e.c.Drums, pulleys, sheaves
An employee was de-energizing a stand-alone three-phase 3,000-kVA transformer. The employee had opened a bay on the switchgear and removed the barrier board covering a 200-amp switch. The employee then used a 6-foot insulated work stick to open the fuse door. As soon as the top of the fuse door separated from the gear's switch bracket, an arc flash occurred, burning the employee's left ear, neck, and cheek area and causing swelling on the employee's lips.
On December 6, 2023, an employee of Duke Energy was working on a single-phase 120-/240-volt parallel service re-tap when a secondary flash occurred in an underground service. The employee suffered a second-degree burn to the face and was hospitalized.
An employee was on a ladder working on an absorber tower. As the employee was taking the unit apart, a part struck him in the face and knocked him off the ladder. The employee sustained facial lacerations.
An employee was working on a transformer, removing the cover inside a cabinet, when an arc flash occurred. The employee sustained second-degree burns to his neck and ears requiring hospitalization.
An employee was hospitalized after he was shot in the leg. The employee was in the parking lot after getting off shift. The gun was in his backpack that dropped on the floor, setting the gun off.
A crew was working near an electrical pole. A co-worker was using a front-loader to grade a slope when the loader slid into a guy-wire and became tangled and stuck. The injured employee used a handheld grinder to cut the wire a few feet from the ground. The lower part of the wire fell to the ground, but the upper part of the wire fell toward the pole and contacted an energized part before the end landed in nearby bushes. The employee attempted to shake the bush to free the wire so it could fall back toward the pole. The wire popped up and contacted his hands, resulting in electrical entry burns to both hands and exit burns on both feet.
On November 18, 2023, two employees were using a 2x4 to lift a power line. The boom lift they were operating made contact with power lines and both employees sustained electrical shock injuries.
An employee was part of a crew that was servicing a power line. The employee was in a bucket truck when he contacted the 7,200-volt power line. The electricity entered through one hand and exited the other, causing several electrical burns. The employee was not wearing proper personal protective equipment at the time.
An employee was helping a crew set up a 45-foot pole between two other poles. It was being set up between two energized lines and the pole made contact with the A-phase. The employee was electrocuted and lost consciousness. The electricity also caused an entry wound in their left forearm and an exit wound in their left foot.
An employee was handling a 45-foot long rebar for installation on the third floor of a building at a 30-foot elevation. The rebar came into close proximity of a powerline situated 13 feet off the building. The employee sustained electrical burns to his hands from electric discharge, requiring hospitalization.
More severe injuries in this industry (NAICS 221122)
An employee was setting up communication equipment for a meeting. They were walking and tripped over a speaker on the ground. The employee sustained a leg injury.
An employee (a lineman) was working to restore power by installing a hand line when he contacted a high-voltage device (7,200 volts), resulting in electrical burns to his upper body and hands.
A chain sling failed while a utility pole was being removed. A chain link struck an employee who was operating a front-end loader, puncturing the employee's chest.
An employee was working with an underground crew to troubleshoot a BUD failure. The employee was removing a fuse from the fuse holder when the fuse blew on the riser and an arc flash occurred. The employee was hospitalized with burns to his face, nose, lips, and neck.
An employee was connecting two wires when his rubber insulated gloves failed and he suffered an electric shock to his right hand, resulting in an electrical burn.
An employee was helping a coworker transport a tall palm tree with a mini skid steer. The employee was severely shocked by a high-voltage electrical wire above the ground.
An employee was retrieving a Christmas tree from a shelf using a ladder. He missed a step and fell to the concrete floor. He sustained injury to his head and wrist.
An employee was operating an agricultural tractor during sugarcane harvesting. The employee sustained a lumbar sprain due to vibration or motion from the tractor.
An employee was moving a 3-ton condensing unit, strapped down on a dolly, out of a garage. The strap broke, causing the employee to fall backward onto the brick pavered driveway. The employee suffered injury to a spinal ligament in the neck.