Struck by falling object or equipment, unspecified · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at JCB Manufacturing, Inc., 2000 Bamford Blvd, POOLER, GEORGIA 31322
on — Fractures, affecting the foot(feet) and leg(s), unspecified.
Final narrative
An employee was using an overhead crane with a two-leg chain sling to lift a loader arm sub assembly. One of the two legs was not attached and was secured on a jib crane in the area when the load was lifted, causing the loader arm sub assembly to fall and strike the employee. They sustained right foot and leg fractures.
HospitalizedFoot(feet) and leg(s), unspecifiedVehicle and mobile equipment parts, n.e.c.
An employee was walking around and performing basic job duties on assembly prior to shipment. They drank from a water bottle that contained windshield washer fluid. The employee sustained stomach injuries and was hospitalized.
The employee had just removed the arm of a skid steer from a fixture using a chain hoist with a hook and placed the arm on the floor. After the arm was placed on the floor, the employee removed the hook and began raising the hook with the hoist. While raising, the hook caught on the side of the arm causing it to turn over onto the employee's lower left leg and fracture it.
An employee was on a surface two feet from the floor, checking the quality of a skid steer. As she pulled on a pin in the skid steer, she slipped and fell onto the floor, resulting in injuries to the right shoulder, face, and head.
An employee was installing a track pod assembly onto an SSL chassis on the main assembly line when their right index finger was trapped between the track pod and chassis, resulting in amputation.
An employee was unloading 30-foot 2-inch barrels from a pan holding about 20 barrels. The barrels tipped over, striking and breaking both of the employee's lower legs.
An employee was in a sandblasting area, preparing the surface of a plate heat exchanger frame for painting. The frame fell on the employee, who suffered fractures to vertebrae, the neck, pelvis, and rib cage; and punctured lungs.
An employee was working behind a stack of steel I-beams (stacked 2 columns deep and 4 levels high on the floor) while a forklift was pushing the stack. When the forklift took off the second-to-last beam, the last one was pushed over, causing it to fall to the ground and strike the employee. The employee sustained a fracture to the right leg.
An employee was lifting a flat sub (sheet steel) in the flats robot cell (weld area). He was operating a hoist when his left little fingertip got caught between the lifting device hook and the flat sub. The employee sustained a partial transphalangeal amputation.
An employee was underneath a 35-foot boom truck and adjusting the transmission linkage when the truck jumped over the wheel chocks and rolled over the employee's right leg, resulting in a fracture.
A crane was being used to lift a debris tank from a rack. The tank crushed the employee's right hand, causing amputations to the employee's right ring finger and little fingertip.
An employee was removing a small sheet metal part out of the die of the brake press. The foot pedal was pressed, causing the part to lift and crush their left thumb against the die. The employee suffered an amputation to the thumb tip including the loss of flesh and the fingernail.
An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.
During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.
An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.