Direct exposure to electricity, unspecified · Third or fourth degree electrical burns
At a glance
Federal OSHA recorded a severe workplace injury
at ELM FieldSight LLC, 4300 Live Oak Drive, THE COLONY, TEXAS 75056
on — Third or fourth degree electrical burns, affecting the hand(s) and arm(s), unspecified.
Final narrative
An employee was installing busbars onto a battery system. A battery circuit was completed and caused an electrical arc. The employee sustained third-degree burns to his arms and hands.
HospitalizedHand(s) and arm(s), unspecifiedElectric parts, unspecified
An employee was installing a 15-amp breaker in an electrical panel when a 12-gauge ground wire touched the positive busbar of the panel, resulting in an arc flash. The employee sustained a second-degree burn to their left hand.
An employee was repairing an HVAC system in the drop tile ceiling of a conference room when they were shocked, causing them to fall from the ladder. The employee sustained burns to their right middle and ring fingers.
An employee was replacing a contactor inside an electrical panel attached directly to a press. The press itself was receiving power from another main panel. After replacing the contactor, the employee flipped the switch and an arc flash occurred, burning the employee's elbow, bicep, and neck.
An employee was attempting to switch a medium-voltage primary cable and install a 200-amp fuse barrel. The employee contacted the bottom of the switch gear cradle for the fuse barrel, causing an arc blast. The electricity entered the employee s left hand and exited his big toes, resulting in electric shock and burns to the left hand, arm, shoulder, and both feet. The employee was hospitalized.
On December 6, 2023, an employee of Duke Energy was working on a single-phase 120-/240-volt parallel service re-tap when a secondary flash occurred in an underground service. The employee suffered a second-degree burn to the face and was hospitalized.
More severe injuries in this industry (NAICS 335911)
An employee was operating material handling equipment when their right foot was caught between the material handling equipment and a railing. The employee sustained fractures to the big toe and second toe.
An employee was operating a forklift when it collided with another forklift at an intersection. The employee suffered a broken lower right leg from a rack of battery plates on the forks of the other truck.
Four employees were moving a 400-pound flange to the ground when part of the load was released and the injured employee's hand became caught between the flange and the ground. The employee sustained a left middle fingertip amputation.
An employee was recycling material by adding it to a molten lead pot. The employee came in contact with the molten lead and suffered burns to the lower back and shoulder.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.