Tri Con Works

On December 31, 2023, an employee was performing sanitation on a packer conveyor and was walking in the passageway when their shirt collar was pulled into the conveyor above the passageway. The employee was strangled and became unconscious. The conveyor was not guarded at the time.

On 12/25/2023, at approximately 1:00 PM, a converting pulp mill was plugged up. An employee was going to use compressed air to clean the machine. He thought he dropped a baffle behind the teeth of the machine. When he reached for the baffle, his cut-resistant glove was caught by the teeth (blades). The employee sustained a laceration and partial amputation to the right index finger.

An employee was clearing a jam in a surge hopper when they sustained a right wrist fracture, three finger amputations, and a laceration. The employee was hospitalized and required surgery.

A maintenance employee was conducting repairs on the conveyor belt of an automatic palletizer. The employee's shirt fell in front of a sensor causing the equipment to energize. The employee's right middle finger was caught by chains within the conveyor belt motor resulting in a partial amputation.

An employee was working as a color weighman operator. The employee located the weigh station hopper and removed the vent sock and clamps to access the inside of the hopper through the vent hole. After using a pole to clear the bottom of the hopper, the employee reached through the vent hole to access the top of the hopper. The employee's right hand came in contact with the rotary air lock, causing partial amputations to two fingers.

An employee was stepping down off a 6-inch containment platform to finish loading his truck, when his right ankle rolled. The employee sustained a fractured tibia and fibula at the right ankle and required surgery.

A service crew was pulling a pump and motor from a well. After breaking a joint of pipe loose from another joint, an employee grabbed the chain tongs to prevent the pipe from spinning in the well, so the crew could continue taking it apart. The bolt that attaches the chain to the handle of the chain tongs broke, causing the chain to swing around and strike the employee's lower right leg. The chain severely punctured his leg and fractured his tibia.

An employee was working to remove a stuck fish tool from a drill shoe. Their thumb was struck by a hammer, resulting in amputation.

An employee arrived on location and loaded a blow-out-preventer (BOP) on a 1-ton flatbed truck. While standing on the flatbed securing the the BOP, the employee stepped into a void/hole on the flatbed surface. This caused him to lose balance and fall off the truck bed with his leg still caught in the hole. As a result, he sustained fractures to his left leg.

An employee was rigging up a location. He was using an Allen wrench to free up rotation and start the drawworks engine manually. The engine rotated and his left little finger became caught between the Allen wrench and the engine. The employee sustained an amputation to his little finger and fractures to his wrist.

After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.

An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.

An employee was inspecting flares processes. The employee received burns to the front side of the body, face and arm from the flares.

An employee was removing plastic material from a production line when the machine cycled and amputated his left index, ring, and little fingers.

An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.