Leading Technology Composites, Inc.

An employee was moving a 3-ton condensing unit, strapped down on a dolly, out of a garage. The strap broke, causing the employee to fall backward onto the brick pavered driveway. The employee suffered injury to a spinal ligament in the neck.

An employee was talking to a child on the playground, when the child grabbed her hand to lead her away. The employee stepped, lost her balance, and fell over. The employee was hospitalized with a fracture of her lower left leg and required surgery.

An employee was lowering a safe stack beam inside a trailer. The beam released, causing the employee to fall back and strike his head on the trailer floor. He was hospitalized with a brain bleed and a concussion.

An employee was on the ground working to close a trailer door. The door was caught by the wind and blew the employee backward. He landed on his back and sustained four fractured ribs, requiring hospitalization.

An employee was pulling a display shipper using the provided strap. The strap broke and the employee fell to the floor, suffering a broken wrist.

An employee was working with fiberglass and resins. The employee was hospitalized after having difficulty breathing caused due to chemical exposure.

The injured employee was letting air out of a winding shaft using scissors as a lift table was used to pull the roll off the shaft. The roll/cardboard core slid over the top of the injured employee's scissors and caused the scissors to amputate the employee's little fingertip at the nail base.

An employee was dropping off a skid of laminate to be cut at a table saw. The skid was lifted and the forks tilted forward when the stack slid forward and struck the injured employee. The employee was pinned between the laminate and the table of the saw, resulting in a back fracture and a laceration to the liver.

An employee was using a machine to cut a roll of plastic sheeting. The employee's right hand was at the end of the roll, and when the cutting mechanism of the machine cycled, the employee's right middle and ring fingers were cut, resulting in amputations to both fingers.

An employee was running acrylic film through an automated winding machine which wraps film around a cardboard cylinder core. He noticed that the film had slipped off the winder. He went to the front of the machine to re-attach the film to the winder spool. His fingers got caught between the film and the spool and his left arm was pulled up by the winder spool. The employee was hospitalized with a broken left forearm. Another employee injured their shoulder when pulling the first injured employee out of the machine.

An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.

An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.

An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.

Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.

An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.