Menards, Store #3132

An employee was operating a metal roller machine to roll a small piece of metal. The employee's right index finger became caught between the metal and the machine, and the fingertip was amputated.

An employee was mixing sauce using a sauce barrel mixer when his left little finger was amputated.

An employee was working on a production line. The employee went to retrieve parts that came out of the parts holder, and their left hand became caught between a chain and a sprocket. Three fingers on the hand were amputated.

An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.

An employee was operating a pad printer. The employee's finger was caught in the printer and they suffered a fingertip amputation. The part of the printer that caught the employee's finger was unguarded at the time.

An employee was backing up an electric pallet jack when it struck a yellow guardrail, pinning his ankle between the pallet jack and the guardrail. The employee suffered a crush injury to his left ankle and shin.

The injured employee was going to use an elevator to go upstairs. The elevator does not have a call button and is operated manually. The employee approached the elevator and used the elevator drop key located in the elevator key box to manually open the door. He then stepped forward into the elevator shaft. The elevator car was on another floor, resulting in the employee falling down the shaft from the first floor to the basement level. The employee was hospitalized with a sprained left hand and bilateral calcaneal fractures.

An employee was aligning a shipping offload conveyor. A component of the machine caught the employee's left middle finger, amputating it above the second knuckle.

An employee was using a torch to burn off liquid petroleum gas from old 100-pound cylinders so they could be recycled. When he went to move a tank, some gas spilled onto the ground, then ignited in a flash that engulfed him. He was burned on the face, hands, and back and was hospitalized.

An employee was escorting a forklift inside a store. While walking backward, the employee tripped on a pallet and fell, suffering a broken hip.

An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.

An employee was walking past a crossover conveyor when a ramp came down and hit them in the back. The employee sustained a broken back vertebra, as well as a concussion, and was hospitalized.

An employee was using a hook tool to pull a pallet onto the lift gate of a tractor trailer. The hook detached from the underside of the pallet, causing the employee to fall backward off the lift gate. The employee landed on the concrete parking lot about 5 feet below, suffering fractures to the skull and two thoracic vertebrae.

A skid loader backed over an employee's leg, breaking it.

An employee was walking on a truss table when he lost his balance and fell approximately 3 feet to the floor. The employee sustained a dislocated and fractured left ankle.