Penn Power Group

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.

An employee was attempting to lift a steel beam from a horizontal, stacked position to a vertical position using a crane. They had placed two hooks on the east side of the beam on the flange. As the employee was hoisting the crane, the beam began to shift and pulled the employee forward onto the stack. When the material shifted, the hooks released and the material fell, pinning the employee between the two beams. The employee was hospitalized with soft tissue contusions on their proximal right thigh and interior left thigh.

An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.

An employee was rigging I-beams. An I-beam slid off the stack of I-beams and fractured the employee's leg.

An employee was repairing the suspension of a semi-trailer. He was installing an air bag to the suspension when his left ring finger was crushed between the air bag and the suspension mounting beam. The employee was hospitalized.

An employee was refueling a pressure washer when it ignited and exploded. He suffered multiple third-degree burns to his chest and hands.

A mechanic had just finished a repair on a straight truck with a flatbed , which had been lifted using a bottle jack. As the employee was about to remove the jack, it failed. The truck shifted forward, dropped down, and struck the employee's chest. He suffered broken ribs and a broken shoulder.

An employee was performing diagnostic work on a vehicle engine. As the employee was leaning over the front of the vehicle, the engine was activated. A fuel leak had produced fumes around the engine, and the ignition spark ignited them. The employee suffered second-degree burns to both hands, both biceps, and the upper chest area.

An employee was hot patching a tire, which involves lighting a flammable liquid on fire to patch the tire. The flammable liquid contacted his arm, and he sustained burns to his arms and face.

An employee was cleaning leaves with a backpack blower when he fell from a ladder, resulting in injuries to his head, neck, and back.

An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.

An employee slipped while descending in a stairwell, fell, and suffered multiple contusions/bruises to the head, neck, shoulders, knees, and back. She was hospitalized.

An employee's right middle finger was caught in a nip point. The employee suffered an amputation to the middle finger at the first knuckle.

An employee was directing trucks as they entered and left a highway work zone. A vehicle struck them, resulting in multiple fractures and other injuries. The employee was hospitalized.