MOSINEE, WISCONSIN—
Kafka Conveyors & Equipment Inc
Struck by dislodged or detached object(s) · Multiple severe wounds and internal injuries
At a glance
Federal OSHA recorded a severe workplace injury at Kafka Conveyors & Equipment Inc, 104424 Karau Ave, MOSINEE, WISCONSIN 54455 on — Multiple severe wounds and internal injuries, affecting the Trunk and other upper extremities.
Final narrative
On March 5, 2024, an employee was removing a trailer's tie-down rachet strap when the banding used to secure a delivery of conveyor support brackets broke. The parts subsequently struck the employee, resulting in a fractured pelvis, shoulder blade, and ribs, as well as internal bleeding.
Similar incidents · Same event type
BLYTHEVILLE, ARKANSAS—
NATIONAL MILL MAINTENANCE, LLC
An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.
PILOT POINT, TEXAS—
C. Miller Drilling Inc
A service crew was pulling a pump and motor from a well. After breaking a joint of pipe loose from another joint, an employee grabbed the chain tongs to prevent the pipe from spinning in the well, so the crew could continue taking it apart. The bolt that attaches the chain to the handle of the chain tongs broke, causing the chain to swing around and strike the employee's lower right leg. The chain severely punctured his leg and fractured his tibia.
ABILENE, TEXAS—
Rolling Frito-Lay Sales, LP
An employee was using a handheld grinder to cut a bolt. The grinding wheel broke apart and a fragment struck the employee s right hand, causing a laceration to the palm near the little finger.
COLUMBUS, OHIO—
Blackburn's Fabrication, Inc.
An employee was operating a brake press when the top die broke, causing the bottom die to roll out and onto the employee's legs. Both of the employee's legs were crushed below the knee, and both legs were partially amputated. The employee's left leg was also fractured above the knee.
ORLANDO, FLORIDA—
Textron Aviation Inc. (Orlando Service Center)
A pressurized aircraft nose landing gear strut assembly was being disassembled. The gland nut dislodged under pressure and made contact with an employee's left hand, breaking it.
More severe injuries in this industry (NAICS 333922)
PANHANDLE, TEXAS—
3S Americas, Inc.
An installation technician for a wind turbine lift was using a chain hoist to move materials up a tower. The chain storage unit overflowed; the chain spilled and fell about 40-50 feet down the tower. It struck the injured employee in the face, causing fractures to their nose and cheekbones.
JONESBORO, ARKANSAS—
Hytrol Conveyor Company, Inc.
On November 25, 2024, at 9:00 a.m., two employees were moving a metal staging pallet that was located in an automation cell. The injured employee slipped and their left middle finger was crushed between the pallet and metal frame of the machine, resulting in an amputation to the finger padding.
JONESBORO, ARKANSAS—
Hytrol Conveyor Company, Inc.
On October 22, 2024, at approximately 10:15 a.m., an employee was forming a stand leg on a standard brake press. As they were readjusting the part, the tip of their right thumb was caught in the brake press, resulting in a partial amputation. The incident occurred during training.
JOHNSTON, RHODE ISLAND—
Dematic Corp
An employee was working on a ladder when he lost his balance and fell onto the conveyor rail, resulting in two broken ribs and hospitalization.
BURLESON, TEXAS—
KWS Manufacturing Company, Ltd.
An employee was cleaning welding debris from a steel part that was in a fixture. The part moved, cut through the employee's cut-resistant glove, and amputated their right middle fingertip.
More severe injuries in WISCONSIN
MADISON, WISCONSIN—
RG Professional Carpenter, Inc.
The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.
FRANKLIN, WISCONSIN—
General Thermodynamics, Inc.
An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.
SAINT CLOUD, WISCONSIN—
Sargento Foods Inc
A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.
HIXTON, WISCONSIN—
Asher Enterprises, Inc.
An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.
VERONA, WISCONSIN—
Consolidated Electrical Distributors Inc.
An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.