Patriot Builders of Wisconsin, LLC

An employee was cutting a board using a circular saw. The saw pinched, kicked back, and cut the employee's left ring and little fingers. The employee suffered an amputation to the little finger.

An employee was cutting wood with a circular saw. The saw kicked back, and its blade cut three fingers on the employee's right hand, resulting in an amputation.

An employee was using a table saw to cut wedges for a deck when the wood jumped and his right palm was lacerated by the blade.

An employee was doing a cutback on a piece of lumber using a chop saw. The saw hit a knot, the piece of lumber buckled, then kicked back and broke the kickback guard. The board was then pulled back into the blade, which lacerated the employee's left index and middle fingers.

An employee was cutting wood with a circular saw. The machine lagged and cut the employee's finger. The employee required surgical amputation of the finger at the hospital.

An employee was standing on trusses while installing shaftwall and metal channel. He slipped from the bottom chords of the 2x6 trusses and fell approximately 1 foot. A metal C-channel caused a severe laceration to his wrist and ulnar artery.

An employee was operating a circular saw when it jumped and contacted three fingers on their left hand, resulting in lacerations and amputations.

An employee was working on a scaffold installing windows when they fell 6 feet to the ground and impacted their head. The employee sustained head trauma.

An employee was standing on a scaffold approximately 7 feet high and passing plywood sheets to another employee on a single-story roof. The employee fell backward off the scaffold to the ground below and the sheet of plywood fell on him, resulting in fractures to the left side of his jaw and three ribs.

On July 25, 2025, an employee was walking on roof trusses when they fell 10 feet to the ground. The employee was hospitalized with a concussion and a back injury.

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.

A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.

An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.

An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.