Struck by rolling powered vehicle or machinery · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at JDHB JV, 11100 Shady Lane, HOUSTON, TEXAS 77093
on — Fractures , affecting the Rib(s), oblique area.
Final narrative
On March 11, 2024, two employees were inside a tunnel cleaning trash and placing it in an electric cart. Trash fell on the accelerator of the electric cart, causing it to start moving forward while the injured employee was directly in front of it. The cart struck the employee, resulting in three fractured ribs that required hospitalization.
Hospitalized Rib(s), oblique area Industrial vehicle, material hauling and transport powered, unspecified
An employee was was exiting a car they were detailing when a malfunction caused it to move. The employee was pinned between the car door and a pole, suffering a lower left leg fracture and crushing injuries.
An employee was operating a tug that had been re-tagged due to faulty brakes. As the employee approached the designated parking area, he slowed the tug using the clutch and then exited the tug. He went to stop the tug from colliding with a concrete wall when his right ankle became caught between the tug and a parking stall barrier. He sustained a fractured ankle and was hospitalized.
An employee was on a tugger. He was backing up to pick up a stack of pallets. While aligning the tugger with the pallets, his left leg was caught and broken between the tugger and a storage rack.
An employee was operating an electric pallet jack. While standing beside the equipment, the pallet jack lurched forward, pinning the employee's leg against racking. The employee was hospitalized with a fractured right ankle.
More severe injuries in this industry (NAICS 237990)
A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.
An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.
Employees were securing the fuel line of an outboard motor in preparation for removing the motor from a small vessel located in the equipment yard. A gasoline-related fire occurred and one employee sustained burns to both hands and forearms.
A marine diver/construction worker was working underwater, using a hydraulic dredge to clear sediment away from the base of a dam. The dredge's suction nozzle began migrating toward him, and then pulled in his right hand and forearm. He sustained compartment syndrome in the hand and forearm.
An employee was standing on a sheet of -inch by 4-foot by 8-foot plywood on top of a rebar mat, supervising his crew. As he was moving to alert the crew to an incoming overhead load, he stepped off the plywood and his left foot slipped through the rebar mat and landed on the rebar mat below. His left ankle was broken and dislocated.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.