Contact with hot objects or substances · Thermal burns third degree or higher
At a glance
Federal OSHA recorded a severe workplace injury
at Aluminum Dynamics Construction Entrance, 3413 Charleigh D Ford Junior Drive, COLUMBUS, MISSISSIPPI 39701
on — Thermal burns third degree or higher, affecting the Wrist(s).
Final narrative
An employee was operating a gasoline-powered pump to remove water from the ground floor sump of a storage building. The pump became blocked and overheated. The employee was removing the blockage when he was sprayed with hot mud and steam, resulting in first- and second-degree burns to his right hand and left wrist, as well as a third-degree burn to the underside of the left wrist.
An employee pulled out a bucket of hot oil from under the fryer. The employee then stood on the table to clean the back wall. He stepped down into the bucket of hot oil, resulting in third-degree burns to his left leg.
An employee was performing maintenance under a kettle. When he removed a tri-clamp on a transfer line, the hot fat and broth material in the kettle poured out onto his arm. The employee was hospitalized with burns.
After completing a run with an oil distributor truck, an employee was working to return (suction) the hot oil to the tank of the truck. When the employee opened one of the valves, hot oil (approximately 385 degrees) sprayed their face, resulting in first-, second-, and third-degree burns.
An employee was filtering a fryer with a fryer filter machine. After going around the corner and then returning to the fryers, the employee stepped into the filter machine. The hot oil burned the employee's right ankle, and the employee was hospitalized.
An employee was using a water hose to clean debris out of the outfeed of a log conditioning vat. Water began entering the vat from the adjoining vat through a void in the separation wall at the infeed of the vats. As the employee was exiting the vat he had been working in using the access opening at the outfeed, hot water exiting the access opening entered the top of his protective hip wader. It pooled at the bottom of the wader and burned his left foot and ankle.
More severe injuries in this industry (NAICS 331313)
An employee was conducting preventative maintenance on an extrusion press and using an impact wrench to remove rivets on the shear cylinder. When the last rivet was removed, the stored energy in the cylinder released and dropped it onto the employee's hand. Their right thumb was caught between the cylinder and the casing of the rivet gun, resulting in crushing injuries. The employee sustained an amputation of the thumb without bone loss. The machine was locked out/tagged out at the time.
An employee stepped on the lip of a deck plate and his foot slipped into a pot of ore, resulting in burns to the lower left ankle and foot. The employee was hospitalized.
An employee was cutting small aluminum parts on a vertical bandsaw when their finger contacted the saw blade, resulting in a partial amputation of the little finger on their left hand.
An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.
The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.
An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.
An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.
An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.