Struck by falling part of vehicle or machine, still attached · Amputations, avulsions, enucleations unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at Danser, Inc., 4110 US-78, LEEDS, ALABAMA 35094
on — Amputations, avulsions, enucleations unspecified, affecting the Finger or thumb tip(s), nail(s).
Final narrative
An employee was removing anchor bolts for a lift table when a hydraulic hose was removed and the hydraulic cylinder released stored energy. This caused the table to fall and crush his thumb between two pieces of metal. The employee sustained a partial amputation of his left thumb tip.
HospitalizedAmputation Finger or thumb tip(s), nail(s) Jacks
An employee was standing at the rear of a machine and the machine's mesh tray fell down onto the rear of the machine, crushing his left hand against the read lift. The employee sustained fractures and a laceration to their left hand and was hospitalized.
An employee had been tasked with hauling large rocks. There was a rock caught in the tailgate of the dump truck that was preventing it from opening. He went to get the rock out and the tailgate came down, crushing his right middle fingertip. The employee sustained a fracture of the distal phalanx and required surgery.
An employee was replacing the wear pan in a wood chipper when a metal sawdust pipe attached to the machine fell from above, pinning him against the machine. The employee suffered a broken right femur, right hip, and left hip.
Two employees were working on a forklift with its mast in the air when a chain came loose and the carriage fell down on them. The injured employee was hospitalized with a fractured left ankle, a laceration on the left side of their forehead, and a fractured L1 vertebra.
An employee was hooking up a hydraulic attachment on a forklift. When pressure was released from the hydraulic system's hose, the arm of the forklift came down on the employee's left foot and broke it.
More severe injuries in this industry (NAICS 332322)
An employee was driving a forklift when its right front wheel dropped off a 6-inch curb. The forklift rolled over and trapped him against the concrete surface. He suffered a broken pelvis, ribs, and collarbone, as well as a collapsed lung.
An employee was operating a brake press when the top die broke, causing the bottom die to roll out and onto the employee's legs. Both of the employee's legs were crushed below the knee, and both legs were partially amputated. The employee's left leg was also fractured above the knee.
An employee was performing routine maintenance on a shear machine when the machine's foot pedal was engaged and the blade contacted his right middle finger, resulting in a partial amputation.
An employee was helping to tighten down a metal packaging band for shipping. The metal band broke and struck the employee across their face, cutting their left face/eye area. The employee was hospitalized.
An employee was traveling down the maintenance aisle of a warehouse on a single-pallet front rider jack. The jack malfunctioned, causing the brakes to apply; the employee fell forward onto the concrete warehouse floor. The employee suffered an injury to the left leg and was hospitalized, requiring surgery.
An employee was operating a metal roller machine to roll a small piece of metal. The employee's right index finger became caught between the metal and the machine, and the fingertip was amputated.
An employee was directing a truck driver to a dump site when the truck's peanut trailer slipped off the kingpin. As the trailer fell, a ladder attached to it lacerated the employee's ear. The employee was hospitalized.
An employee was unloading a forklift from a trailer to the ground. The employee was climbing down the ladder of the trailer when their foot slipped through one of the rungs, causing them to fall backward onto the forklift forks. The employee was hospitalized for fractured ribs.