Nonroadway noncollision fall or jump from moving vehicle · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at Acme Erectors, Inc., 3400 Pershall Rd, SAINT LOUIS, MISSOURI 63135
on — Fractures , affecting the Upper arm(s).
Final narrative
An employee was driving a scissor lift (in the down position) up a wooden site-built ramp. He had to turn the lift to the right as he started climbing the ramp. The left front wheel of the lift dropped off the edge of the ramp, causing the lift to tilt slightly to the left. The employee jumped out and landed on his right elbow on the concrete floor. His humerus was broken just above the elbow.
Two employees were unloading a steel column from a flatbed tractor trailer. The two-point rigging configuration slipped on the load as it was being hoisted off the trailer. The two rigging points slid on the column and came together, causing one end of the column to strike the injured employee's arm. The employee was knocked down, and he landed on his side on the flatbed trailer. The end of the column then landed on his hip. The employee was hospitalized with a fractured arm and pelvis and required surgery.
An employee was traveling down the maintenance aisle of a warehouse on a single-pallet front rider jack. The jack malfunctioned, causing the brakes to apply; the employee fell forward onto the concrete warehouse floor. The employee suffered an injury to the left leg and was hospitalized, requiring surgery.
An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.
An employee was riding a four-wheeler while moving cattle into another pen when they were thrown off the vehicle and landed on the ground. The employee sustained fractures to their upper arm, pelvis, and right leg.
An employee was moving a stand-up powered industrial truck from a warehouse to a service area. During a turn on a slight decline, the vehicle's steering chain broke and the vehicle spun. The employee fell off the vehicle and landed on his right knee, breaking his fibula.
Two employees were operating a paving machine at approximately 1 mile per hour. The paver made a sudden turn, that threw the injured employee off balance. He reached for the handhold next to him and missed, falling 6 inches off the platform to the ground. The adjustable handle for the wing on the paving machine went between his left-hand fingers with the full weight of his body. The employee suffered a closed fracture of the fourth metacarpal bone in his hand.
More severe injuries in this industry (NAICS 238120)
An employee fell from a step ladder while reaching for a tie-off point. He impacted the ground, and landed on his bolt bag which contained tools. The employee was hospitalized with fractured ribs, and a lacerated spleen and kidney.
An employee was attempting to lift a steel beam from a horizontal, stacked position to a vertical position using a crane. They had placed two hooks on the east side of the beam on the flange. As the employee was hoisting the crane, the beam began to shift and pulled the employee forward onto the stack. When the material shifted, the hooks released and the material fell, pinning the employee between the two beams. The employee was hospitalized with soft tissue contusions on their proximal right thigh and interior left thigh.
An employee was standing on the surface of a steel beam about two feet wide. He slipped and fell backward, landing on the concrete ground about 20 feet below. The employee sustained a broken pelvis.
An employee was unloading a rebar delivery from a flatbed, 19-wheel trailer. The employee rigged the load with wire rope chokers. The load was picked up 3-4 feet above the trailer deck by a crane. The load began to swing and the employee grabbed onto it to prevent it from being pushed off the trailer deck. The crane continued to lift the load, and the employee let go so the crane did not lift him to the third story. The employee fell approximately 12 feet to the ground below, resulting in a back injury and fractured vertebrae.
An employee was attaching a steel angle plate weighing (approximately 200 pounds) to the end of a structural member (5,000 pounds) and was supported by dunnage. The dunnage was a crane mat (11 inches tall) with a 4x6 board on top of it and it supported five identical members. The main piece was 30.75 feet long, 37.25 feet tall, and 1 food wide. As the employee slid the piece of metal on top of the member to begin attaching it, the entire member began to tip over. The employee went to stop the main piece from tipping over and it landed on his ankle, fracturing it.
An employee was readjusting a safety hook to remove hardware from gang forms when his feet slipped. He fell to the ground, resulting in a broken left arm and wrist.
An employee was on a step ladder in a store aisle, making room on shelving for merchandise. She fell from the step ladder to the floor, suffering two fractures in her left leg. She was hospitalized, requiring surgery.
An employee was closing the side cargo door to a company van. The tip of his finger got caught between the door and the door jamb, resulting in a partial amputation.
An employee lost his footing while climbing an inclined ladder. He stumbled down one step and was able to stabilize himself by holding the railing and twisting his body, but he suffered an internal abdominal injury and was hospitalized.