North Star Terminal & Stevedore Co., LLC

An employee was using his left hand to push an axle down the line on a raised track work area while holding the remaining axle back with his right hand. A finger on his right hand was caught between the rail and the dust guard of the axle, resulting in a fracture and a laceration.

An employee was moving metal out of a cart. He had removed one piece and was working to move another when the metal shifted. His right ring finger was crushed between the two pieces, and he suffered a partial amputation to the finger pad at the tip.

A load of steel angles was being lowered when the lifting chain hit the load, causing it to slide toward an employee. An angle slid and pinched the employee, catching both of their legs between the beams and an angle. The employee suffered two fractured legs.

Employees were replacing a 24" pig trap door. A strap was shackled on the pig trap door and connected to a forklift. Welders began to cut the door off. An employee was holding onto the door when the cut was finished. The door shifted and caught his fingers, resulting in a hand injury and amputation.

An employee used a crane to set down a bar. The bar measured 9 inches by 16 feet. The strap got stuck under the bar, and the employee asked another employee to jog the roll. The bar rolled and pinched the injured employee's left hand, resulting in a fingertip amputation.

While preparing to install a new spool piece for a vapor and spent sulfuric acid line, an employee was working to ensure there was no residual product or pressure in the line before removing the 6-inch hose. The valve was cracked, and some spent acid still in the line sprayed out. The employee was standing off to the side and at a distance, but was still contacted by the hot acid, resulting in corrosive and thermal burns to their upper torso and mid-thighs of both legs.

An employee was driving a utility tractor rig when it struck the rear trailer of another utility tractor rig, which was traveling in the opposite direction. The glancing impact caused damage to the cab, and he sustained a laceration on right side of his face, a cervical fracture, two fractured left ribs, and a pelvic fracture. The employee was hospitalized.

The injured employee was standing by the controls for the electric spud system on the barge, preparing to raise the spuds. Meanwhile, an excavator was moving a mat on the deck. As the excavator swung from port to starboard, it's counterweight struck the injured employee s shoulder, causing them to lose balance and fall against the spud controls. The employee sustained bruises and contusions to their right shoulder and chest.

An employee was standing on the outside edge of a hopper barge while watching a skid steer push ore for an excavator (with a clamshell bucket) to unload. The excavator was on a work barge. The bucket of the excavator struck the employee and caused a near-amputation of their right arm and fractures of the ulna and radius of the left arm. The right arm required surgery.

An employee was inspecting a conveyor to see why it was not running. The employee entered the the conveyor motor area, tripped on a piece of angle iron welded to the floor, and fell. The employee sustained a fractured orbital bone.

An employee was assisting with pre-welding setup on pile structures at the fuel dock worksite. They were working to operate a come-along to align a waler to the pile. Due to limited leverage and restricted positioning within the man basket of the crane, the employee exited the basket to manually adjust the waler from the structure itself. During the task, wave height and frequency increased. A large wave struck the area, causing the pile braces and walers to shift. The employee lost their footing and grabbed the production pile edge. Their fingers on one hand were crushed between two structural steel piles. The employee sustained an amputation to the fingers and was hospitalized.

An employee was lifting a manhole cover when it fell on his right foot, resulting in the amputation of his big toe and the adjacent toe.

An employee was in a tunnel freezer, which was being turned on for the first time. The baffling for the evaporator fan got stuck in the siding. The employee ascended a 5'9"-tall cart to reach the raised baffling panel. The raised baffling shifted and dropped, trapping the employee's arm between the aluminum and foam core baffling. The employee sustained a severe laceration to the lower forearm/upper wrist and severed ligaments. The employee was hospitalized.

An employee was engaging in daily physical training in preparation for fire season as a smokejumper. The employee sustained swelling and stiffness in their arms and was hospitalized with rhabdomyolysis.

An employee was training and running and suffered rhabdomyolysis.