Air Power Systems Company

An employee was hooking up a set of 28-foot trailers, attaching a converter dolly to the lead trailer's pintle hook. He backed up the lead trailer and parked it a foot from the converter dolly, then lifted the converter dolly and rolled it to the lead trailer to set it onto the hook. The converter dolly kicked up, and the employee's left hand was caught between it and the trailer. He suffered a severe laceration to the palm between the ring finger and middle finger.

An employee in the warehouse was working to pull a reel from under a rack when his finger was crushed between the reel and the rack. The employee sustained a fingertip amputation.

An employee was pushing automotive suspension material using a material rack. The material started to shift and caught the employee's right little finger, crushing it. The employee suffered an amputation to the finger. The finger was re-attached.

An employee was entering a receiving area to start his shift when he was struck by a utility cart being pushed by another employee. The injured employee fell to the floor and suffered a fractured hip.

A temporary employee was moving an I-beam that was on a steel table to the edge of the table. Their right index finger was pinched between the I-beam and the table, resulting in a broken finger.

An employee was working in the shipping/receiving area on a packing paper dispenser that was jammed. When the paper came free, the blade pulled the paper in and pulled the employee's hand in too, amputating about a quarter of the right middle fingernail and the top of the finger.

On June 27, 2025, at approximately 7:00 PM, an employee was operating a cell that presses rings on a cylinder and welds the rings on. The cylinder was moving between the welding station and the press station when it fell off the holder. The employee went to place the cylinder back on the holder when the cell cycled and the compression holder crushed their right hand. The employee's middle, ring, and little fingers were crushed.

An employee was working on a hydraulic cylinder at his work table. While he was removing a bleeder plug to reduce the pressure, the 3/8-inch steel plug was pushed out by oil pressure. The plug impacted his wrist, causing an abrasion where hydraulic oil went into his arm. The employee was hospitalized.

An employee was using a hydraulic press to repair a hydraulic tool that was stuck in the open position. Upon adding downward pressure from the hydraulic press, the tool's hydraulic quick coupler broke and released the ball bearing inside the coupler. The ball bearing struck the employee in the abdomen, resulting in lacerations and abrasions. The ball bearing also penetrated the employee's abdomen.

An employee was operating a manual tube lathe when a piece of metal stringer (twine rope) caught his left forearm, resulting in a laceration. The employee was hospitalized and had surgery.

An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.

An employee was working in the food service warehouse when he experienced chest pain, difficulty breathing, and lost consciousness. The employee sustained carbon monoxide poisoning.

An employee was cutting a piece of metal rod with a metal cutting machine. His right middle finger became caught between the rod and the machine's table. The employee's fingertip was partially amputated.

An employee was working at her desk. She went to stand up and fell to the floor beside the desk. The employee sustained a hip displacement and required surgery.

An employee was processing wood boards at a chop saw when the saw malfunctioned and the blade cut her left hand and fingers. She was hospitalized and her little finger was surgically amputated.