Standridge Color Corporation

An employee was cleaning out a hopper when his hand slipped and contacted the rotor, resulting in a right middle finger amputation at the base of the nail and damage to the index finger.

An employee was attempting to clean out the auger area of a machine when the auger caught and amputated the employee's left middle finger. The machine was running at the time.

An employee's fingertip was caught and amputated in a paper coating machine. The machine was not locked and/or tagged out at the time.

The injured employee was assisting in the disassembly phase after a radar array had been lowered and secured. The crew began removing load bearing pins from an overhead crane to free the radome. A load bearing pin was stuck. The injured employee went to remove the pin manually as a second team member applied pressure from the opposite side. The pin unexpectedly released and struck the injured employee s right thumb, resulting in partial amputation of the distal phalanx including an open distal phalanx fracture and nail bed laceration.

An employee was shoveling excess material (spillage) that consisted of dry mix, sand, aggregate and cement. As he was shoveling, some material blew back in his face and around his safety glasses. He got a piece of metal in his left eye that required surgery. The employee was hospitalized.

An employee was feeding boards into an edger. They fed a board in and then adjusted the blade for a second board that was wider. When they fed the second board into the edger, it hit the first board and kicked back, striking the employee in the chest. They sustained injuries including a spine fracture, an injured pancreas, as well as potential injuries to their spleen, liver, and intestine. The employee was hospitalized and required surgery.

An employee was helping an operator to pull a cable off a winch. The operator pulled in the line when it hooked some tree brush. The brush then whipped around and struck the employee's arm, resulting in a broken arm.

A co-worker was adjusting an overhead bracket with an impact wrench when the tool flew out of their hand and struck the injured employee in the face. The injured employee sustained an injury to their left eye.

An employee placed an aluminum step ladder beside a tractor trailer and was removing a piece of scrap aluminum from the trailer that resulted from a motor vehicle accident. While coming down the ladder, the employee fell approximately 6 feet to the concrete. The employee was hospitalized with a fractured T4 vertebra.

On August 26, 2025, an employee was repairing a pipe at a tank. The employee fell and slid down the tank, suffering severe lacerations to the lower arms. The employee was hospitalized.

On August 26, 2025, a temporary employee was assisting a mechanic. The employee was on an overhead crane, removing a chain hoist attachment over a large plating tank. When the platform of the crane was moved, the employee became caught between the platform's railing and a support beam. The employee sustained a punctured lung and fractures to their clavicles, humerus, and ribs.

An employee was adding an all purpose soak and electro cleaner chemical to a water tank to make a cleaner bath. An exothermic reaction caused the 200 F water to splash on him, and he suffered hot water and steam burns to the right side of his face, his upper right arm, the right side of his torso, and his right leg.

At 3:00 AM, on 2/18/2025, an employee was mixing chemicals. The employee had difficulty breathing due to inhalation of unknown chemicals. The employee was hospitalized.

An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.

A casting machine jammed. An employee's hand was caught in the machine, where a belt line caught and amputated the tip of his finger.

During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.

An employee slipped on condensation on a walkway in a parking garage. She fell and suffered a closed fracture to the neck of the left femur.

An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.