Nonroadway noncollision fall or jump from moving vehicle · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at MARTAM CONSTRUCTION, INC., 1671 E. Oakton St., DES PLAINES, ILLINOIS 60016
on — Fractures , affecting the Trunk and other upper extremities.
Final narrative
An employee was operating a concrete buggy when a piece of concrete debris became lodged in the tracks, causing the buggy to come to a sudden stop. The employee was thrown from the buggy and landed on the ground on his left side resulting in a broken arm and two broken ribs.
Hospitalized Trunk and other upper extremities Industrial vehicle, material hauling and transport powered, n.e.c.
An employee was digging in an excavation less than five feet deep to locate existing underground utilities. Side wall shear occurred in the excavation and the employee was struck by loose pieces of asphalt pavement and soil in the lower half of their body. The employee sustained a fractured pelvis.
On March 5, 2015, an employee was hospitalized after suffering a foot injury on the job. The employee was standing next to a trench at ground level while lowering a concrete pipe into the ground when the pipe struck the employee in the leg.
An employee was traveling down the maintenance aisle of a warehouse on a single-pallet front rider jack. The jack malfunctioned, causing the brakes to apply; the employee fell forward onto the concrete warehouse floor. The employee suffered an injury to the left leg and was hospitalized, requiring surgery.
An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.
An employee was riding a four-wheeler while moving cattle into another pen when they were thrown off the vehicle and landed on the ground. The employee sustained fractures to their upper arm, pelvis, and right leg.
An employee was moving a stand-up powered industrial truck from a warehouse to a service area. During a turn on a slight decline, the vehicle's steering chain broke and the vehicle spun. The employee fell off the vehicle and landed on his right knee, breaking his fibula.
Two employees were operating a paving machine at approximately 1 mile per hour. The paver made a sudden turn, that threw the injured employee off balance. He reached for the handhold next to him and missed, falling 6 inches off the platform to the ground. The adjustable handle for the wing on the paving machine went between his left-hand fingers with the full weight of his body. The employee suffered a closed fracture of the fourth metacarpal bone in his hand.
More severe injuries in this industry (NAICS 237310)
An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.
An employee was cleaning out an inlet pipe in a stormwater structure. The employee stepped back, fell into the pipe, and landed on concrete 13 feet below, at the bottom of the structure. He suffered a broken back.
A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.
An employee was operating a roller and paving a small pathway next to a pavilion. The ground was on a slight pitch, causing him to reach up toward the roll cage to stabilize himself. His right fifth finger was pinched between the roll cage and the rafter of the pavilion. The employee sustained a partial degloving injury with partial traumatic amputation.
An employee was working with paving equipment and heard a noise on the opposite side of the machine he was working on. When the machine stopped, the employee went to the opposite side and crouched down to investigate the noise. A mini track loader backed up and drove over the employee's leg. The employee sustained fractures to their lower leg, ankle, and foot.
An employee was changing a die in a press when the die slipped and crushed the employee's left index finger. The employee sustained an open facture of the tuft of the left distal phalanx and a partial amputation.
An employee was driving a boom lift (in the lowered position) in an exterior dock area. The lift s left wheels rolled onto base plates that covered a 3-foot-deep sump pit. The base plates failed, and one side of the lift dropped. The employee's left leg was caught under the lift basket, and he suffered a fracture to the lower leg including the ankle.