105,313Records 71,083Employers 85,290Hospitalizations 27,770Amputations 2015-01-01 2025-10-31
Safety Incidents OSHA Severe Injury Reports · 2015–2025

Bill's Electric, Inc.

Other fall to lower level less than 6 feet · Cerebral and other intracranial hemorrhages without skull fracture

Federal OSHA recorded a severe workplace injury at Bill's Electric, Inc., 601 South Riverview Dr, BIXBY, OKLAHOMA 74008 on — Cerebral and other intracranial hemorrhages without skull fracture , affecting the Brain.

Watch Bill's Electric, Inc. — free Get an email when a new federal OSHA severe-injury report for Bill's Electric, Inc. is published. One employer, no account, unsubscribe in one click.

An employee was on an A-frame ladder pulling a wire through a conduit. The pressure caused the head to break from the fish tape, which caused the employee to lose his balance and fall approximately 5 feet, striking his head on the concrete. The employee sustained a brain bleed and injuries to the back of his head that required stitches.

Hospitalized Brain Step ladders

Bill's Electric Inc.

On June 24, 2021, at 11:00 a.m., an employee was on a scissor lift 20 feet high splicing wires together from a panel to the rooftop units inside junction boxes. The employee was shocked, causing him to fall out of the scissor lift onto the ground and resulting in contusions and bruising that required hospitalization.

BILL'S ELECTRIC, INC.

An employee was performing an electrical study. While he was taking a fluke meter reading on the building's main switch gear (1600A, 480V 3 phase), an arc flash occurred and the fluke meter blew up in his hands. He suffered second degree burns to the hands, arms, neck, face, and eyes, requiring hospitalization. PPE was not worn at the time.

View Bill's Electric, Inc.'s full OSHA safety record →

A&S Services Group

An employee fell while exiting a trailer. The employee landed on their left side on the pavement, suffering multiple broken ribs on the left side. The employee was hospitalized.

Kisatchie Midnight Express

A driver was exiting his vehicle outside the plant gate when his foot slipped on the top step of the truck. He fell to the ground, landed on his left hip and elbow. The employee was hospitalized with a fractured hip/femur.

Lockheed Martin Mission Systems and Training

Two employees were removing a service lift platform from the back of a radar system. While handling the service lift platform, employee 2 was standing on the back of the radar and lost their footing, causing the service lift platform to shift and fall. The injured employee then fell from the top of the platform electronic subsystem (PES) to the floor, approximately 56 inches. The injured employee fractured his left elbow and left hip.

Allen Tharp LLC.

An employee fell from a loading dock to the ground 2-3 feet below. She suffered a compound fracture of the left hip and was hospitalized, requiring surgery.

Allied Waste Systems Inc

An employee assisted in cleaning material from a conveyor pit. After the pit was cleaned, the employee proceeded to replace metal safety plates to ensure other employees did not fall into the pit. While replacing one of the last plates, the employee mis-stepped and fell approximately 5 feet into the pit. The employee was hospitalized with back/side bruising, elbow bruising, bone bruises, and/or fractured ribs.

Smart Building Technologies - A Fidelity Company

An employee was troubleshooting the control setup for a variable air volume box above a ceiling. The employee's hand came into contact with an exposed, energized 277-volt wire that had loosened from its terminal on the box's assembly. He was shocked and fell off a ladder. His left hand passed across the ceiling grid and was lacerated. He also suffered an electrical burn to the right hand and was hospitalized.

Abbott Electric Inc

An employee was moving a scissor lift through a doorway. The employee was pinned between the scissor lift and the doorframe, sustained a back injury, and was hospitalized.

Mintcrest Corp

An employee was standing on an A-frame ladder approximately 6 feet above the floor while he attached a suspended light fixture to the ceiling. The employee lost balance, and fell to the tiled floor below, sustaining blunt force trauma to his head.

Cupertino Electric, Inc.

An employee was inspecting the overhead area of a single-person lift and repositioning the lift through a double doorway. As they were transitioning through the doorway, they were caught between the doorframe and the vertical mast of the lift. The employee was hospitalized with injuries to the nose, left maxillary sinus, left orbital bone, and left jaw, with fractures at the maxillary sinus area.

Swedberg Electric, LLC

The injured employee was performing routine maintenance on a fan belt/pulley. The injured employee and another person were moving the pulley back and forth manually to find a bearing issue. The injured employee's left ring finger got caught between the belt and the pulley wheel, resulting in a soft tissue amputation.

Rae Corporation

An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.

Meeco Sullivan

An employee was cutting a piece of metal rod with a metal cutting machine. His right middle finger became caught between the rod and the machine's table. The employee's fingertip was partially amputated.

Edward Jones Investments

An employee was working at her desk. She went to stand up and fell to the floor beside the desk. The employee sustained a hip displacement and required surgery.

Burgess Manufacturing of Oklahoma Inc.

An employee was processing wood boards at a chop saw when the saw malfunctioned and the blade cut her left hand and fingers. She was hospitalized and her little finger was surgically amputated.