DENVER, COLORADO—
Excel Energy
Direct exposure to electricity greater than 220 volts · Electrocution, electric shock
At a glance
Federal OSHA recorded a severe workplace injury at Excel Energy, 2070 South Valentia Street, DENVER, COLORADO 80231 on — Electrocution, electric shock, affecting the BODY SYSTEMS .
Watch Excel Energy — free
Get an email when a new federal OSHA severe-injury report for Excel Energy is published. One employer, no account, unsubscribe in one click.
Final narrative
An employee was repairing a power distribution pole and contacted an energized conductor, resulting in electric shock.
Similar incidents · Same event type
ASSUMPTION, ILLINOIS—
J F Electric, Inc.
A crew was changing out a single-phase pole. The injured employee was framing the pole approximately 30 feet from the base. As they were loosening the armor rod clamp, the conductor broke and the wire fell to the ground, landing on the employee's right hand. The employee suffered electrical burns to their right hand and both knees.
COLLINSVILLE, ALABAMA—
Cherokee Electric Cooperative
An employee (a lineman) was working to restore power by installing a hand line when he contacted a high-voltage device (7,200 volts), resulting in electrical burns to his upper body and hands.
STEPHENVILLE, TEXAS—
Scott Pole Line, LLC
An employee was working from a bucket truck to remove a bolt from an attachment on an energized power line pole. The employee came into contact with the energized phase, resulting in an electrical shock of 7,200 volts. The employee was hospitalized. Protective gloves were not worn at the time of the incident.
WASHINGTON COURT HOUSE, OHIO—
Mega Communications
On September 29, 2025, an employee was installing a fiber optic line at a residential site. His shoulder contacted the 7,600-kilowatt power line, resulting in an electrical shock. The employee was hospitalized.
BENNINGTON, OKLAHOMA—
Metts Powerline Construction, Inc.
Two employees exited their vehicle to assess a fully-downed power pole. The injured employee approached the downed pole to examine it more closely when their feet got caught underneath the energized phase and the ground of the pole, resulting in electrical burns to both feet.
More severe injuries in this industry (NAICS 221122)
COLUMBUS, OHIO—
American Electric Power Company
An employee was setting up communication equipment for a meeting. They were walking and tripped over a speaker on the ground. The employee sustained a leg injury.
COLLINSVILLE, ALABAMA—
Cherokee Electric Cooperative
An employee (a lineman) was working to restore power by installing a hand line when he contacted a high-voltage device (7,200 volts), resulting in electrical burns to his upper body and hands.
LA PORTE, TEXAS—
Centerpoint Energy Houston Electric, LLC
A chain sling failed while a utility pole was being removed. A chain link struck an employee who was operating a front-end loader, puncturing the employee's chest.
VOORHEES, NEW JERSEY—
Public Service Electric & Gas
An employee was working with an underground crew to troubleshoot a BUD failure. The employee was removing a fuse from the fuse holder when the fuse blew on the riser and an arc flash occurred. The employee was hospitalized with burns to his face, nose, lips, and neck.
SOUR LAKE, TEXAS—
Bright Star Solutions, Inc
An employee was connecting two wires when his rubber insulated gloves failed and he suffered an electric shock to his right hand, resulting in an electrical burn.
More severe injuries in COLORADO
GREELEY, COLORADO—
ABC Supply Company
An employee was delivering materials. He was doing his pre-delivery inspection on the roof of the jobsite (a warehouse) when he fell through a plexiglass skylight. He landed on his feet on the concrete floor 14 feet below. The employee sustained fractures to his spine, left ulnar/radius, and right heel. The employee required surgery.
BOULDER, COLORADO—
Burke Builders Inc
An employee was cutting cabinet trim using a table saw when four fingers on his left hand were severed, resulting in hospitalization and amputation.
LONGMONT, COLORADO—
Circle Graphics, Inc.
An employee was removing packaging from a roll of printing substrate. The blade of their utility knife got stuck. The employee used both hands to free the knife and the blade partially amputated their left little fingertip.
DENVER, COLORADO—
FLATIRON CONSTRUCTION CORP.
A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.
BURLINGTON, COLORADO—
Takkion OPS Management
An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.