105,313Records 71,083Employers 85,290Hospitalizations 27,770Amputations 2015-01-01 2025-10-31
Safety Incidents OSHA Severe Injury Reports · 2015–2025

Skanska USA Civil Northeast Inc.

Struck by running powered equipment n.e.c. · Amputations, avulsions, enucleations unspecified

Federal OSHA recorded a severe workplace injury at Skanska USA Civil Northeast Inc., 1242 Viele Ave, BRONX, NEW YORK 10474 on — Amputations, avulsions, enucleations unspecified, affecting the Finger or thumb tip(s), nail(s).

An employee was cutting plywood strips for edge forms using a circular saw. The employee was cutting with the plywood nailed down to the table and two hands on the saw. While cutting, the saw bound up momentarily. The employee lost his grip and brought his left hand to the table to catch himself. At this point, the saw reengaged and amputated the tip of his left index finger.

Amputation Finger or thumb tip(s), nail(s) Saws except chainsaws

Skanska USA Civil Northeast Inc.

An employee was loading palleted joint baskets onto a flatbed truck using slings. Baskets on the flatbed began to tilt and the employee fell/jumped from the flatbed. Baskets then landed on their legs and the employee sustained a suspected tendon rupture in the right knee.

Skanska USA Civil Northeast Inc.

At 1:18 p.m. on February 2, 2023, employees were moving an 8-by-10-foot road plate, weighing about 3,000 pounds, using a front loader with a fork attachment. The fork was being used to raise one end of the plate so that dunnage could be inserted between it and the plate it was stacked on. The plate slid off the fork while it was 6 inches off the ground and struck the front of an employee s left foot. He suffered a displaced fracture to the last joint of his left big toe.

Skanska USA Civil Northeast, Inc.

An employee was manually unloading a truck when a U-shaped steel column fell on the employee causing a deep laceration to the left thigh.

Skanska USA Civil Northeast Inc.

An employee broke his leg tripping over light-pole foundation footing while trying to run out of the way of a falling security fence.

View Skanska USA Civil Northeast Inc.'s full OSHA safety record →

T G Meat Center LLC

After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.

Burke Builders Inc

An employee was cutting cabinet trim using a table saw when four fingers on his left hand were severed, resulting in hospitalization and amputation.

LMMM Houston #80, LTD.

An employee was using a meat saw to slice pork when the blade amputated their right little fingertip.

Electric Boat Corporation

An employee was struck by a plasma cutter and suffered a broken left tibia and fibula. The employee was hospitalized.

General Thermodynamics, Inc.

An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.

HB Fleming, Inc.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

Takkion OPS Management

An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.

Ahtna Marine and Construction Company, LLC

Employees were securing the fuel line of an outboard motor in preparation for removing the motor from a small vessel located in the equipment yard. A gasoline-related fire occurred and one employee sustained burns to both hands and forearms.

Michels Construction, Inc

A marine diver/construction worker was working underwater, using a hydraulic dredge to clear sediment away from the base of a dam. The dredge's suction nozzle began migrating toward him, and then pulled in his right hand and forearm. He sustained compartment syndrome in the hand and forearm.

Bechtel Energy Construction Services, Inc.

An employee was standing on a sheet of -inch by 4-foot by 8-foot plywood on top of a rebar mat, supervising his crew. As he was moving to alert the crew to an incoming overhead load, he stepped off the plywood and his left foot slipped through the rebar mat and landed on the rebar mat below. His left ankle was broken and dislocated.

Garden Angels New York LLC

An employee was cleaning leaves with a backpack blower when he fell from a ladder, resulting in injuries to his head, neck, and back.

Cashless Tolling Constructors

An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.

NYU Langone Hospital-Brooklyn

An employee slipped while descending in a stairwell, fell, and suffered multiple contusions/bruises to the head, neck, shoulders, knees, and back. She was hospitalized.

VILLAGER CONSTRUCTION, INC.

An employee was directing trucks as they entered and left a highway work zone. A vehicle struck them, resulting in multiple fractures and other injuries. The employee was hospitalized.